Abstract:In this paper, a novel kind of method to monitor corrosion expansion of steel rebars in steel reinforced concrete structures named fiber optic coil winding method is proposed, discussed and tested. It is based on the fiber optical Brillouin sensing technique. Firstly, a strain calibration experiment is designed and conducted to obtain the strain coefficient of single mode fiber optics. Results have shown that there is a good linear relationship between Brillouin frequency and applied strain. Then, three kinds of novel fiber optical Brillouin corrosion expansion sensors with different fiber optic coil winding packaging schemes are designed. Sensors were embedded into concrete specimens to monitor expansion strain caused by steel rebar corrosion, and their performance was studied in a designed electrochemical corrosion acceleration experiment. Experimental results have shown that expansion strain along the fiber optic coil winding area can be detected and measured by the three kinds of sensors with different measurement range during development the corrosion. With the assumption of uniform corrosion, diameters of corrosion steel rebars were obtained using calculated average strains. A maximum expansion strain of 6,738 με was monitored. Furthermore, the uniform corrosion analysis model was established and the evaluation formula to evaluate mass loss rate of steel rebar under a given corrosion rust expansion rate was derived. The research has shown that three kinds of Brillouin sensors can be used to monitor the steel rebar corrosion expansion of reinforced concrete structures with good sensitivity, accuracy and monitoring range, and can be applied to monitor different levels of corrosion. By means of this kind of monitoring technique, quantitative corrosion expansion monitoring can be carried out, with the virtues of long durability, real-time monitoring and quasi-distribution monitoring.

Experimental Research on Monitoring Concrete Expansion and Cracking Induced by Corrosion based on Distributed Optical Fiber Sensor

Experimental Research on Corrosion-Induced Cracking Monitoring Based on Optical Fiber Sensor

Experimental Research on Concrete Crack Recognizing and Monitoring Based on Distributed Fiber Sensor

An Optical Fiber Sensor Method for Simultaneously Monitoring Corrosion and Structural Strain Induced by Loading

A Monitoring Method Based On Fbg For Concrete Corrosion Cracking

Towards an Automated Crack Monitoring using Distributed Fiber Optic Sensors

Distributed cracks detection by BOTDA and its application in corrosion cracking monitoring

Crack monitoring on concrete structures with distributed fiber optic sensors—Toward automated data evaluation and assessment

Monitoring the Corrosion Process of Reinforced Concrete Using BOTDA and FBG Sensors

Experimental and Numerical Investigation into Corrosion-Induced Mortar/concrete Cracking with Distributed Optical Fiber Sensors

Cracking Monitoring Method and Experiment with Distributed Fiber Sensor

Brillouin Corrosion Expansion Sensors for Steel Reinforced Concrete Structures Using a Fiber Optic Coil Winding Method.

An Experimental Investigation on Continuous Strain and Crack Monitoring with Fiber Optic Sensors

Monitoring Concrete Deterioration Due to Reinforcement Corrosion by Integrating Acoustic Emission and Fbg Strain Measurements

Evaluation of Corrosion Expansion of Reinforced Concrete Specimen Using Fiber Optical Brillouin Sensing Technique

Corrosion Monitoring of Flexural Reinforced Concrete Members under Service Loads Using Distributed Long-Gauge Carbon Fiber Sensors

Deformation monitoring and numerical simulation of prestressed concrete beam with local corrosion and fracture of prestressed steel

Research on corrosion monitoring for steel-reinforced concrete structures using fiber optic sensing technique

Localization and Monitoring of Initiation and Propagation of Corrosion-Induced Mortar Cracking Based on OFDR Distributed Optical Fiber Sensor

Damage Evaluation of Concrete Based on Brillouin Corrosion Expansion Sensor

Research On Corrosion Detection For Steel Reinforced Concrete Structures Using The Fiber Optical White Light Interferometer Sensing Technique