Abstract:We investigated the utility of a modified Washburn method, combining results of two sorption experiments, to study wettability alteration processes. The main objective in deploying this technique was to avoid the difficulty of direct contact angle measurements in surfactant solutions. In such cases, the ultra-low interfacial tension between the crude oil and surfactant tends to cause the oil drop to spread prematurely rendering the measurement unreliable if possible at all. A carbonate-rock, dead crude oil, synthetic brines including SmartWater, and five surfactants were used in this study. The surfactants included: an anionic alfa olefin sulfonate, a cationic quaternary ammonium salt, an amphoteric surfactant, a nanosurfactant, and a nonionic ethoxylated alchohol. Hexane was also used as a reference completely wetting fluid. For sorption experiments, the rock was powdered. The powder with size between 80 and 100 mesh was compacted in the sample holder. In each experiment, a given fluid was raised to the bottom of the powder pack and allowed to rise into the powder by capillarity. A sensitive balance was used to measure fluid imbibition into the powder until no more fluid imbibes. Beside sorption experiments, surface and interfacial tension measurements were made. For benchmarking, we relied on previous findings reported in the literature. Plotting the square of fluid mass against time gave a slope which enabled the calculation of contact angle in air. The results (slope) observed for the completely wetting fluid (hexane) provided the rock constant. Sorption results of crude oil coupled with the previously determined rock constant enabled estimation of the Wasburn oil/air contact angles using the modified Washburn equation. Sorption results with brine and surfactant solutions coupled with the rock constant and oil/air enabled estimation of the Washburn water/air contact angles using the modified Washburn equation. Based on water/air and oil/air contact angles, values of the conventional oil/water contact angle were estimated. For surfactant solutions, interfacial tension between oil and surfactant-free brine were used to approximate contact angles that were otherwise undefined. This approach, enabled a robust and rapid estimation of the effects of various processes on contact angles (hence wettability alteration). Based on the benchmark previous findings, the sorption approach yielded acceptable results especially for screening purposes. The results demonstrated the potential of the Smartwater recipe and the nonionic surfactant for wettability alteration. However, it is recommended to rely on the sorption method direct measurements including sorption rates to establish sorption-based wettability indices and eliminate the intermediary and probably unnecessary contact-angle estimation step. In conclusion, the use of sorption to obtain contact-angle estimates provide a novel rapid and robust procedure for evaluation and screening of wettability-alteration agents. This eliminates direct contact angle measurements that are often cumbersome. It specifically eliminate the difficulties of attaching an oil drop onto a rock surface immersed in surfactant solutions.

Wettability of Oil-Producing Reservoir Rocks as Determined from X-ray Photoelectron Spectroscopy

Effect of Heavy Constituent in Crude Oil on Wettability Change of Sandstone

Evaluation of Wettability Alteration by Oil Doped with Organic Acid and Low-High Brine Solutions in Sandstone and Carbonate Rocks

Pore-scale Imaging and Characterization of Hydrocarbon Reservoir Rock Wettability at Subsurface Conditions Using X-ray Microtomography

Pore-Scale Imaging of Controlled-Salinity Waterflooding in a Heterogeneous Carbonate Rock at Reservoir Conditions

The Influence of Oil Composition, Rock Mineralogy, Aging Time, and Brine Pre-soak on Shale Wettability

Study of Surface Wettability of Mineral Rock Particles by an Improved Washburn Method

A thermodynamically consistent characterization of wettability in porous media using high-resolution imaging.

A Ph-Resolved Wettability Alteration: Implications for CO2-Assisted EOR in Carbonate Reservoirs

Oil/water/rock wettability: Influencing factors and implications for low salinity water flooding in carbonate reservoirs

Effect of Electrokinetics and Thermodynamic Equilibrium on Low-Salinity Water Flooding for Enhanced Oil Recovery in Sandstone Reservoirs

Wetting Behavior Of Shale Rocks And Its Relationship To Oil Composition

Experimental investigation on molecular-scale mechanism of wettability alteration induced by supercritical carbon dioxide-water-rock reaction

Understanding the Interfacial Wettability of Reservoir Rock at Nanoscale

Ph Effect on Wettability of –Nh+-Brine-muscovite System: Implications for Low Salinity Effect in Sandstone Reservoirs

Effect of Anionic Surfactants on the Oil-Water-Rock Interactions by an Improved Washburn Method

Ion-induced Wetting Transition During Low Salinity Waterflooding

Investigation of Wettability Alteration Processes for Carbonates using the Washburn Contact Angle Method with Two Sorption Fluids

Wettability Effects on Capillary Pressure, Relative Permeability, and Irredcucible Saturation Using Porous Plate

Pore-Scale Investigation of Low-Salinity Nanofluids on Wetting Properties of Oil Carbonate Reservoir Rocks Studied by X-ray Micro-Tomography

Wettability of rock minerals and the underlying surface forces: A review of the implications for oil recovery and geological storage of CO2