Abstract:We investigated the utility of a modified Washburn method, combining results of two sorption experiments, to study wettability alteration processes. The main objective in deploying this technique was to avoid the difficulty of direct contact angle measurements in surfactant solutions. In such cases, the ultra-low interfacial tension between the crude oil and surfactant tends to cause the oil drop to spread prematurely rendering the measurement unreliable if possible at all. A carbonate-rock, dead crude oil, synthetic brines including SmartWater, and five surfactants were used in this study. The surfactants included: an anionic alfa olefin sulfonate, a cationic quaternary ammonium salt, an amphoteric surfactant, a nanosurfactant, and a nonionic ethoxylated alchohol. Hexane was also used as a reference completely wetting fluid. For sorption experiments, the rock was powdered. The powder with size between 80 and 100 mesh was compacted in the sample holder. In each experiment, a given fluid was raised to the bottom of the powder pack and allowed to rise into the powder by capillarity. A sensitive balance was used to measure fluid imbibition into the powder until no more fluid imbibes. Beside sorption experiments, surface and interfacial tension measurements were made. For benchmarking, we relied on previous findings reported in the literature. Plotting the square of fluid mass against time gave a slope which enabled the calculation of contact angle in air. The results (slope) observed for the completely wetting fluid (hexane) provided the rock constant. Sorption results of crude oil coupled with the previously determined rock constant enabled estimation of the Wasburn oil/air contact angles using the modified Washburn equation. Sorption results with brine and surfactant solutions coupled with the rock constant and oil/air enabled estimation of the Washburn water/air contact angles using the modified Washburn equation. Based on water/air and oil/air contact angles, values of the conventional oil/water contact angle were estimated. For surfactant solutions, interfacial tension between oil and surfactant-free brine were used to approximate contact angles that were otherwise undefined. This approach, enabled a robust and rapid estimation of the effects of various processes on contact angles (hence wettability alteration). Based on the benchmark previous findings, the sorption approach yielded acceptable results especially for screening purposes. The results demonstrated the potential of the Smartwater recipe and the nonionic surfactant for wettability alteration. However, it is recommended to rely on the sorption method direct measurements including sorption rates to establish sorption-based wettability indices and eliminate the intermediary and probably unnecessary contact-angle estimation step. In conclusion, the use of sorption to obtain contact-angle estimates provide a novel rapid and robust procedure for evaluation and screening of wettability-alteration agents. This eliminates direct contact angle measurements that are often cumbersome. It specifically eliminate the difficulties of attaching an oil drop onto a rock surface immersed in surfactant solutions.

Study of Surface Wettability of Mineral Rock Particles by an Improved Washburn Method

Effect of Heavy Constituent in Crude Oil on Wettability Change of Sandstone

Effect of Anionic Surfactants on the Oil-Water-Rock Interactions by an Improved Washburn Method

Comparison of Different Methods to Determine the Surface Wettability of Fine Solids Isolated from Alberta Oil Sands

Investigation of Wettability Alteration Processes for Carbonates using the Washburn Contact Angle Method with Two Sorption Fluids

Study on the mechanical mechanism of dynamic wetting of sodium dodecyl sulfonate solutions containing inorganic salt additives

Impact of surface roughness on wettability of oil-brine-calcite system at sub-pore scale

Experimental investigation on molecular-scale mechanism of wettability alteration induced by supercritical carbon dioxide-water-rock reaction

Surface modeling of wettability transition on α-quartz: Insights from experiments and molecular dynamics simulations

The Influence of Oil Composition, Rock Mineralogy, Aging Time, and Brine Pre-soak on Shale Wettability

Molecular dynamics simulation of the surface wettability of typical minerals in shale

The Role of the Spatial Heterogeneity and Correlation Length of Surface Wettability on Two-Phase Flow in a CO2-water-rock System

A thermodynamically consistent characterization of wettability in porous media using high-resolution imaging.

Understanding the Interfacial Wettability of Reservoir Rock at Nanoscale

Effects of swelling-clay and surface roughness on the wettability of transitional shale

Wettability of Oil-Producing Reservoir Rocks as Determined from X-ray Photoelectron Spectroscopy

Experimental investigation on the effects of deep eutectic solvents (DES) on the wettability of sandstone samples

Exploring Wettability Variations on Minerals Surfaces: Insights from Spreading Coefficient and Interaction Energy Analysis

Direct Measurement of the Contact Angle of Water Droplet on Quartz in a Reservoir Rock with Atomic Force Microscopy

Oil/water/rock wettability: Influencing factors and implications for low salinity water flooding in carbonate reservoirs

A Regulation Method of the Wettability of Solid Surfaces: Oil–Water Wettability Alteration by Replacing Adsorbed Polar Molecules Via Salt Ions