Abstract:A discrete element method (DEM) model is developed to simulate the dynamics of wet, flexible fibers. The angles of repose of dry and wet fibers are simulated, and the simulation results are in good agreement with experimental results, validating the wet, flexible fiber model. To study wet fiber flow behavior, the model is used to simulate shear flows of wet fibers in a periodic domain under Lees-Edwards boundary conditions. Significant agglomeration is observed in dilute shear flows of wet fibers. The size of the largest agglomerate in the flow is found to depend on a Bond number, which is proportional to liquid surface tension and inversely proportional to the square of the shear strain rate. This Bond number reflects the relative importance of the liquid-bridge force to the particle's inertial force, with a larger Bond number leading to a larger agglomerate. As the fiber aspect ratio (AR) increases, the size of the largest agglomerate increases, while the coordination number in the largest agglomerate initially decreases and then increases when the AR is greater than four. A larger agglomerate with a larger coordination number is more likely to form for more flexible fibers with a smaller bond elastic modulus due to better connectivity between the more flexible fibers. Liquid viscous force resists pulling of liquid bridges and separation of contacting fibers, and therefore it facilitates larger agglomerate formation. The effect of liquid viscous force is more significant at larger shear strain rates. The solid-phase shear stress is increased due to the presence of liquid bridges in moderately dense flows. As the solid volume fraction increases, the effect of fiber-fiber friction coefficient increases sharply. When the solid volume fraction approaches the maximum packing density, the fiber-fiber friction coefficient can be a more dominant factor than the liquid bridge force in determining the solid-phase shear stress.

The influence rule of uneven input sliver on floating fiber motion during the dynamic drafting process

The influence of the friction field on accelerating position distribution

High‐fidelity Random Fiber Distribution Algorithm Based on Fiber Spreading Process

Isometric fiber distribution in the roller drafting zone

A Force Model in Single Grain Grinding of Long Fiber Reinforced Woven Composite

Modeling of Tension Control System with Passive Dancer Roll for Automated Fiber Placement

CABLE SLIDING ANALYSIS CONSIDERING FRICTIONAL EFFECT

Discrete element simulation studies of angles of repose and shear flow of wet, flexible fibers.

Effect of Dowel Joints on Dynamic Behavior of Train–discrete Floating Slab Track System

A Further Study of Inverted Hydrodynamic Drafting for Flow Past Two Flexible Filaments in Tandem Arrangement

Orientation Distribution and Rheological Properties of Fiber Suspensions Flowing Through Curved Expansion and Rotating Ducts

Effect Of Fiber Additives On Flow In Journal Bearings

Investigation of the interactions between two contact fibers in the fiber suspensions

Orientation Distribution of Fibers and Rheological Property in Fiber Suspensions Flowing in a Turbulent Boundary Layer

Experimental study on the maximum static friction coefficient of fiber winding based on semi‐geodesic method

Study on the friction characteristics of the bonding point of variable cross-section three-dimensional braided yarn increase based on the bonding method

A yarn-scale woven fabric model including significant slippage formulated within the Arbitrary Lagrangian Eulerian framework

Optimization of the rod chain model to simulate the motions of a long flexible fiber in simple shear flows

Influence of Tension–shear Coupling on Draping of Plain Weave Fabrics

An Improved Nonlinear Model Considering Relative Velocity for the Friction Behavior Between Untwisted Glass-Fiber Tow and Roller

Effects of Structural Parameters on Fiber Volume Fraction of 3D Woven Composites