Abstract:This paper presents a method for measuring, identifying, and compensating the pose errors of a six-axis gantry automated fiber placement (AFP) machine. Due to the particularity of the elastic pressure roller (EPR) of the end-effector, a calibration method of the pressure roller coordinate system is proposed. In order to quickly measure the pose of the EPR, a special pose measurement tool is designed. Based on the screw theory and homogeneous transformation matrix, ideal forward and inverse kinematic models are established and verified on the actual placement path. According to the geometric errors and the offset errors of the machine coordinate system obtained by the analysis, the pose error transfer model of the AFP machine is established. Considering the position and orientation accuracy of the EPR, a comprehensive optimization objective function is established, and all the pose errors are identified synchronously using the Levenberg-Marquardt optimization algorithm, which greatly reduces the pose errors of the AFP machine. Finally, the G codes are modified by combining the iterative method and the inverse kinematic model to realize the compensation of the pose errors. To comprehensively verify the effect of pose error compensation, path control points are randomly selected on the placement paths of the fuselage panel in four directions to compensate the pose errors. The experimental results show that the method proposed in the article can effectively improve the pose accuracy of the AFP machine, so as to meet the requirements of placement accuracy.

Modeling of Precise Tension with Passive Dancers for Automated Fiber Placement

Modeling of Tension Control System with Passive Dancer Roll for Automated Fiber Placement

Fiber Tension Prediction and Control Methods in Automated Fiber Placement

Modeling of tow tension fluctuations and parameter optimization during the stable transfer phase for automated fiber placement

Kinematic Modeling and Parameter Identification for a Heavy Gantry-Type Automated Fiber Placement Machine Considering Gravity Deformation

Kinematic Modeling and Error Parameter Identification of Automated Fiber Placement Machine Based on Measured Data

An Analytical Model for Pressure Distribution in Automated Fiber Placement on Irregular Surfaces and Its Application in Aeronautical Manufacturing

Modeling and Compensation of Volumetric Errors for a Six-Axis Automated Fiber Placement Machine Based on Screw Theory

Measurement, Identification, and Compensation of Pose Errors for Six-Axis Gantry Automated Fiber Placement Machine

As-built FE Thermal Analysis for Complex Curved Structures in Automated Fiber Placement

Periodic Tension Disturbance Attenuation in Web Process Lines Using Active Dancers

Process-dependent Wrinkle Formation for Steered Tow During Automated Fiber Placement: Modeling and Experimental Verification

Modeling and experimental validation of compaction pressure distribution for automated fiber placement

Continuous Stiffness Optimization of Mobile Robot in Automated Fiber Placement

A Modeling and Calibration Method of Heavy-Duty Automated Fiber Placement Robot Considering Compliance and Joint-Dependent Errors

Characteristics of active and passive dancers: A comparative study

Determination and application of posture adjustable domain under constraints of placement quality

Dynamic Model of Flexible Structures with Twisted-and-Coiled Polymer Actuators

Influences of Wrinkles Induced by Tows’ Offset in Automated Fiber Placement on the Bending Properties of Composites

DYNAMIC CONTROL OF TENSION STRUCTURES

Deformation and Fracture Mechanisms of Automated Fiber Placement Pre-Preg Laminates under Out-of-plane Tensile Loading