Abstract:Prepreg tack plays a crucial role in dominating the part quality during the automated fiber placement (AFP) process. This study aims to study the effect of process parameters on the tackiness between prepreg plies for two kinds of prepreg materials and find the optimal combination for high resultant tackiness. Moreover, the surface characteristics are utilized to evaluate the tack-determining mechanism. For this proposal, a shear test method based on the theoretical model is first developed to measure the tackiness between prepreg plies. Thereafter, the influence of each process parameter including lay-up speed, compaction force, and material temperature on the tackiness is investigated and analyzed through the single-factor method. The results show that process parameters exhibit distinct impacts on the tackiness for two kinds of prepreg systems while the tackiness force of the EH918 prepreg is much lower than that of the M21C prepreg. It is because the resin layer on the surface of the EH918 prepreg is much thinner and even in comparison with that of the M21C prepreg. Finally, the response surface method is utilized to investigate the interaction among process parameters and find the optimal combination for high tackiness. It is shown that different prepreg materials present the distinct optimal combination for high resultant tackiness. These results are significant for controlling the tackiness of prepreg materials by tailoring process parameters to satisfy the specific manufacturing requirements.

Modeling of tow tension fluctuations and parameter optimization during the stable transfer phase for automated fiber placement

Fiber Tension Prediction and Control Methods in Automated Fiber Placement

Modeling of Tension Control System with Passive Dancer Roll for Automated Fiber Placement

Process-dependent Wrinkle Formation for Steered Tow During Automated Fiber Placement: Modeling and Experimental Verification

Modeling of Precise Tension with Passive Dancers for Automated Fiber Placement

Numerical and experimental study of the viscosity and mechanical parameters effect on tow feeding quality during automated fiber placement

Influences of Wrinkles Induced by Tows’ Offset in Automated Fiber Placement on the Bending Properties of Composites

An Analytical Model for Pressure Distribution in Automated Fiber Placement on Irregular Surfaces and Its Application in Aeronautical Manufacturing

Kinematic Modeling and Parameter Identification for a Heavy Gantry-Type Automated Fiber Placement Machine Considering Gravity Deformation

As-built FE Thermal Analysis for Complex Curved Structures in Automated Fiber Placement

Determination and application of posture adjustable domain under constraints of placement quality

Continuous Stiffness Optimization of Mobile Robot in Automated Fiber Placement

Modeling and Compensation of Volumetric Errors for a Six-Axis Automated Fiber Placement Machine Based on Screw Theory

Kinematic Modeling and Error Parameter Identification of Automated Fiber Placement Machine Based on Measured Data

Multilayer Modeling Framework for Analyzing Thermo-Mechanical Properties and Responses of Twisted and Coiled Polymer Actuators

Modeling and experimental validation of compaction pressure distribution for automated fiber placement

Analysis and Characterization of Interlaminar Tack for Different Prepreg Materials During Automated Fiber Placement

Research on the Mechanism of Variable Stiffness of the Twisted and Coiled Polymer Actuator During Saturated Contraction

Deformation and Fracture Mechanisms of Automated Fiber Placement Pre-Preg Laminates under Out-of-plane Tensile Loading

Formation Mechanism and Modeling Method of Wrinkling Defects in Variable Angle Tow Steering Fiber Placement

Experimental investigation and modeling study of the fiber orientation behavior