Abstract:Methods of analysis of theoretical and actual contact areas of fibre tows. Weaving is the predominant technology for fabricating carbon fiber composite preforms. Carbon fibers are subjected to various forms of reciprocating friction in the weaving process. Especially, the friction between carbon tow and heddle eyes is difficult to describe due to the complex conditions of variable tension. In this study, a novel experimental simulator was developed to characterize the friction behavior between warp yarn and heddle eye under periodic tension variation. The friction force (Ff) and coefficient of friction (COF) under variable tension conditions were tested. To investigate the variation of real contact area between carbon tow and heddle eyes under variable tension conditions, a silicon‐film indentation method was developed, and the effect of pre‐tension on carbon tow was obtained by combining three‐dimensional micro surface morphology and Hertz analysis methods. The results indicated that both the COF and Ff decreased with increasing pre‐tension. 3D morphology analysis suggested that the tow contact area reached its maximum when the pre‐tension was 1.2 N. In the Hertzian calculation of the actual contact area, the change of the contact area and the pre‐tension was generated by taking into account the evolving contact length, which differed from the measured friction force value by a constant factor. Highlights A variable tension device was designed and developed. The friction between carbon tow and heddle eye was simulated under variable tension. The Ff and COF under different pre‐tensions were tested. A silicon‐film indentation method was proposed. The relationship between contact area and friction was studied.

An Improved Nonlinear Model Considering Relative Velocity for the Friction Behavior Between Untwisted Glass-Fiber Tow and Roller

Process-dependent Wrinkle Formation for Steered Tow During Automated Fiber Placement: Modeling and Experimental Verification

Woven Geotextile Permeability under Uniaxial and Laterally Constrained Conditions

Study on automated geometric modeling for glass fiber woven fabric

Design Research on Roller of New Fiber Carding Machine

Yarn/Yarn Friction Analysis Considering the Weaving Process of Textile Fabrics: Analytical Model and Experimental Validation

Numerical and experimental study of the viscosity and mechanical parameters effect on tow feeding quality during automated fiber placement

Experimental simulation of friction and wear between carbon fiber tow and heddle eye under periodic tension during the 3D weaving process

A mesoscopic model for inter-yarn friction

The influence of the friction field on accelerating position distribution

An Anisotropic Hyperelastic Constitutive Model for Plain Weave Fabric Considering Biaxial Tension Coupling

Influence of Tension–shear Coupling on Draping of Plain Weave Fabrics

A Model of Friction Reduction with In-Plane High-Frequency Vibration

Nonlinear characteristics and a new fractional constitutive model for warp-knitted NCF composites under normal loading conditions

Study on the friction characteristics of the bonding point of variable cross-section three-dimensional braided yarn increase based on the bonding method

Experimental study on the maximum static friction coefficient of fiber winding based on semi‐geodesic method

A Statistical Model and Experimental Study of the Strain Rate and Temperature Dependence of the Strength of Fibers

A Study of the Static/Kinetic Friction Behavior of PTFE-Based Fabric Composites

Numerical model of unidirectional CFRP in machining: Development of an amended friction model

Relationship between the real contact behavior and tribological characteristics of cotton fabric

From mixed to hydrodynamic regime in lubricated sliding of carbon fiber tows