Abstract:Due to native deficiency of the interfacial mismatch between Al2O3 and Al-melt, as well as micron-Al2O3 segregation at matrix grain boundaries (GBs), achieving both high strength and fracture toughness has been the long-lasting challenge for Al-CuO composite fabricated by conventional casting. Herein, we report a novel manufacturing of Al-CuO composite via shift-speed ball-milling (SSBM) of Al-5 wt.% CuO powders and afterwards subjected to hot-pressing (HP) as well as heat treatment. Comprehensive characterization shows that in-situ generation of the two types of Al2O3 with intragranular distribution, including δ*-Al2O3 particles (∼200 nm) and γ-Al2O3 whiskers (length of ∼150 nm, thickness of ∼20 nm), was governed by a diffusion-assisted nucleation-regime ascribing to the intense thermal effect of Al-CuO reaction. The size and spatial distribution of Al2O3 were emphasized to address their contribution to the high mechanical performance of the composite, which exhibits a tensile strength of ∼481 MPa and fracture elongation of ∼16.8 %. Meanwhile, the toughening mechanism of present Al-CuO composite was rationalized on basis of the "dislocation punched zone" and "plastic zone" affected by Al2O3. Both the theoretical analysis and fracture morphology support a reinforcements-matrix interface failure mechanism and the non-uniform distribution of Al2O3 consisting alternant "rich/poor zones" can markedly contribute to the high toughness. The present findings may provide a promising strategy to achieve an intragranular distribution of nano-sized reinforcements in Al-metal oxides composites, which enables increasing strength and ductility of the metal matrix.

Improving mechanical properties of copper composite by interconnected MoO2 quantum dots

Enhancing mechanical properties of copper matrix composite by adding SiO2 quantum dots reinforcement

Effects of composite oxide addition on the microstructure and properties of ODS copper

Improved mechanical-physical performances of copper composites with reduced graphene oxide and carbonized polymer dots as multi-scale synergetic reinforcements

Enhancing mechanical properties of pure copper-based materials with CrxOy nanoparticles and CNT hybrid reinforcement

A high strength and high electrical conductivity copper based composite enhanced by graphene and Al2O3 nanoparticles

Multiphase strengthening mechanism of Cu-Y2O3/W composites prepared by mechanical alloying

Simultaneously enhanced strength and ductility of copper composites by tailoring the intragranular carbonized polymer dots distribution

Synergetic strengthening effects on copper matrix induced by Al2O3 particle revealed from micro-scale mechanical deformation and microstructure evolutions

Improving comprehensive performance of copper matrix composite by spray pyrolysis fabricated CNT/W reinforcement

Preparation and properties of copper matrix composites synergistically strengthened by Al2O3 and CPD

High strength-tough and super-dispersed carbonized polymer dots reinforced copper composites fabricated by ultrasonic spray pyrolysis

Achieving a better mechanical enhancing effect of carbonized polymer dots than carbon nanotubes and graphene in copper matrix

Revealing the strengthening and toughening mechanisms of Al-CuO composite fabricated via in-situ solid-state reaction

Synergistic outstanding strengthening behavior of graphene/copper nanocomposites

Research status and development trend of preparation technology of ceramic particle dispersion strengthened copper-matrix composites

Copper Matrix Composites Reinforced with Nanometer Alumina Particle

A Simple Approach to Obtaining Enhanced Mechanical Properties of Graphene/copper Composites with Heterogeneous Grain Structures

Effect of nano-Y2O3 on the microstructure and mechanical properties of Cu-10W composites prepared by spark plasma sintering

Influence of carbonized polymer dot (CPD) structure on mechanical and electrical properties of copper matrix composite

Enhancement of ultimate tensile strength and ductility of copper matrix composites using a low content of single-wall carbon nanotubes