Abstract:Electrochromic niobia (Nb205) coatings were prepared by the sot-gel spin-coating and d.c. magnetron sputtering techniques. Parameters were investigated for the process fabrication of sol-gel spin coated Nb205 films exhibiting high coloration efficiency comparable with that d.c. magnetron sputtered niobia films. X-ray diffraction studies (XRD) showed that the sot-gel deposited and magnetron sputtered films heat treated at temperatures below 450°C, were amorphous, whereas those heat treated at higher temperatures were slightly crystalline. X-ray photoelectron spectroscopy (XPS) studies showed that the stoichiometry of the films was Nb205. The refractive index and electrochromic coloration were found to depend on the preparation technique. Both films showed low absorption and high transparency in the visible range. We found that the n, k values of the sot-gel deposited films to be lower than for the sputtered films. The n and k values were n = 1.82 and k = 3 × 10−3, and n = 2.28 and k = 4 × 10−3 at 530 urn for sot-gel deposited and sputtered films, respectively. The electrochemical behavior and structural changes were investigated in 1 M LiC104/propylene carbonate solution. Using the electrochemical measurements and X-ray photoelectron spectroscopy, the probable electrode reaction with the lithiation and delithiation is Nb2O5 + x Li+ + x e− ↔ LixNb205. Cyclic voltametric (CV) measurements showed that both Nb205 films exhibits electrochemical reversibility beyond 1200 cycles without change in performance. “In situ” optical measurement revealed that those films exhibit an electrochromic effect in the spectral range 300 < λ < 2100 nm but remain unchanged in the infrared spectral range. The change in visible transmittance was 40% for 250 nm thick electrodes. Spectroelectrochemical measurements showed that spin coated films were essentially electrochemically equivalent to those prepared by d.c. magnetron sputter deposition.

Memristive effect in niobium oxide thin films obtained by the pulsed laser deposition

Laser synthesis of volatile memristors based on niobium oxide thin films

Resistive switching in Nb-doped SrZrO3 memory films: An effective approach with a Cu modulation layer

Enhancement in neuromorphic NbO2 memristive device switching at cryogenic temperatures

Impact of Electrolyte Incorporation in Anodized Niobium on Its Resistive Switching

Thermal Conductivity of Amorphous NbOx Thin Films and Its Effect on Volatile Memristive Switching

Anatomy of Vertical Heteroepitaxial Interfaces Reveals the Memristive Mechanism in Nb 2 O 5 -Nanbo 3 Thin Films

Measurement of the Crystallization and Phase Transition of Niobium Dioxide Thin-Films for Neuromorphic Computing Applications Using a Tube Furnace Optical Transmission System

Electrochemical and Electrochromic Properties of Niobium Oxide Thin Films Fabricated by Pulsed Laser Deposition

Bipolar resistive switching characteristics of atomic layer deposited Nb2O5 thin films for nonvolatile memory application

Growth and Characterization of Polycrystalline NbO2 Thin Films on Crystalline and Amorphous Substrates

Oscillation Neuron Based on Threshold Switching Characteristics of Niobium Oxide Films

Neuronal Firing Characteristics in the NbO2 Based Mott Memristor

Coherent Vibrational Dynamics of NbO2 Film

Optical and electrochemical characteristics of niobium oxide films prepared by sol-gel process and magnetron sputtering A comparison

Resistance switching in amorphous and crystalline binary oxides grown by electron beam evaporation and atomic layer deposition

The fabrication of LiNbO3 memristors for electronic synapses using oxygen annealing

Effect of Nio Growth Conditions on the Bipolar Resistance Memory Switching of Pt/Nio/Sro Structure

Noise Spectroscopy and Electrical Transport in NbO2 Memristors with Dual Resistive Switching

Interfacial Resistive Switching of Niobium–Titanium Anodic Memristors with Self-Rectifying Capabilities

Structural and electrical characterization of NbO2 thin film vertical devices grown on TiN-coated SiO2/Si substrates