Abstract:When integrating a dynamometer into a machining system, it's necessary to identify the dynamic relationship between the effective input forces and the measured output signals (i.e., its transmissibility) through dedicated experimental modal analysis. Subsequently, a filter can be derived and applied to reconstruct the effective input forces from the measured signals. Unfortunately this identification phase can be complex, posing challenges to the device's applicability in both laboratory and industrial conditions. Here this challenge is addressed by introducing a novel dynamometer concept based on both load cells and accelerometers, along with a Universal Inverse Filter. Notably, this filter is independent of the dynamic behavior of the mechanical system where the device is installed. A single calibration suffices, ideally conducted by the device manufacturer or by an expert, allowing the dynamometer's integration by a non-expert user into any machining system without the need for repeating the identification phase and the filter generation. Furthermore, this new concept offers another significant advantage: it attenuates all inertial disturbances affecting the measured signals, including those arising from the cutting process and those originating from exogenous sources such as spindle rotation, linear axes' movements, and other vibrations propagating through the machine tool structure. To illustrate, a simplified model is introduced initially, followed by an overview of the novel dynamometer design, innovative identification phase, and filter construction algorithm. The outstanding performance of the novel (non-parametric) Universal Inverse Filter - about 5 kHz of usable frequency bandwidth along direct directions and 4.5 kHz along cross dir. - was experimentally assessed through modal analysis and actual cutting tests, compared against state of the art filters. The efficacy of the new filter, which is even simpler than its predecessors, was successfully demonstrated for both commercial and taylor-made dynamometers, thus showing its great versatility.

Development and testing of a stationary dynamometer using cross-beam-type force-sensing elements for three-axis cutting force measurement in milling operations

Development of a Tri-Axial Cutting Force Sensor for the Milling Process.

Design and Development of a Tri-Axial Turning Dynamometer Utilizing Cross-Beam Type Force Transducer for Fine-Turning Cutting Force Measurement

Design and Development of a Three-Component Force Sensor for Milling Process Monitoring

A Novel Dynamometer for Monitoring Milling Process

Development and Testing of a Wireless Multi-Axis Toolholder Dynamometer for Milling and Drilling Process

Development of a universal, machine tool independent dynamometer for accurate cutting force estimation in milling

Cutting Forces Measurement for Milling Process by Using Working Tables with Integrated PVDF Thin-Film Sensors.

A Novel Smart Toolholder with Embedded Force Sensors for Milling Operations

Milling Force Monitoring with Thin-Film Sensors Integrated into Fixtures

Design and Fabrication of a Triaxial Cutting Force Dynamometer Based on MEMS Technique

Integrated cutting force measurement system based on MEMS sensor for monitoring milling process

Design and Calibration of a Cutting Force Dynamometer

Research on Multi-points Measurement of a Novel Alternate Arrangement Dynamometer Model

Development of the Piezoelectric Dynamometer for Brittle Material Drilling

Development of Three-Dimensional Dynamometer for Wafer Grinder

Design and Fabrication of a Miniature Four-Axial Piezoresistive Force/Torque Sensor with MEMS Technology

Design and Evaluation of a Low-Cost Electromechanical System to Test Dynamic Performance of Force Sensors at Low Frequencies

Machining Vibration Monitoring Based on Dynamic Clamping Force Measuring in Thin-Walled Components Milling

Theoretical and experimental research of six-dimensional force / moment measurement piezoelectric dynamometer

Research on the Structure and Signal Transmission of Rotary Piezoelectric Dynamometer