Abstract:Due to moisture in the ore, auxiliary material, and ladle refractory material, the hydrogen element is easily enriched in molten steel. In the metallurgy process, some hydrogen atoms form bubbles and are removed by gravity, whearas others solidify in the strand and remain in the produced steel. When the hydrogen content reaches a certain critical value, the enriched hydrogen atoms congregate to produce a white spot, which greatly reduces the strength and toughness of the steel product, and leads to brittle fracture during its service period. At present, the RH (Ruhrstahl–Heraeus) and VD (vacuum degasser) refining processes are commonly applied in steel plants, which can reduce the hydrogen content to less than 2×10−6. With the demand for high quality steel, the hydrogen content must be further decreased, so hydrogen diffusion in solid steel during the annealing process is gradually attracting increasing attention. In this study, a two-dimensional model was built to investigate the characteristic of dehydrogenation in the bloom annealing process of rail steel. Moreover, the effect of annealing temperature and annealing time on hydrogen diffusion were analyzed, and the annealing parameters were optimized. During the dehydrogenation annealing process, the hydrogen content at the corners and edges of the bloom are found to decrease rapidly, while that in the center of the strand begin to decrease in the later heating stage. As the annealing temperature increases, the starting point of dehydrogenation in the bloom center moves ahead and the maximum dehydrogenation rate increases significantly. With the extension of the soaking period, the central hydrogen content of bloom decreases significantly, but the increase rate of the dehydrogenation gradually decreases. By optimizing the bloom annealing parameters, the hydrogen content in the bloom can be steadily reduced to 0.6×10−6, which fully meets the requirement of high quality steel production.

Optimization of Hydrogen-Based Shaft Furnace Raw Material Parameters Based on Numerical Simulation and Rist Operation Diagram

Study on optimization of reduction temperature of hydrogen-based Shaft Furnace—Numerical simulation and multi-criteria evaluation

A Numerical Study of the Thermochemical and Aerodynamic States of H2‐intensive Direct Reduction Shaft Furnace

Computational analysis of hydrogen reduction of iron oxide pellets in a shaft furnace process

An Analysis of Long-Process Ironmaking in a Reduction Smelting Furnace with Hydrogen-Enriched Conditions

Numerical Investigation of the Limit of Coke Rate Reduction in an Ironmaking Blast Furnace (BF)

Operation enhancement of the H 2 shaft furnace: a numerical study on the impact of N 2 mixing in feed gas

Development and progress on hydrogen metallurgy

A Numerical Study on the Process of the H2 Shaft Furnace Equipped with a Center Gas Distributor

Hydrogen reduction of iron oxides in shaft furnaces

Modelling a DR shaft operated with pure hydrogen using a physical-chemical and CFD approach

Hydrogen steelmaking. Part 1: Physical chemistry and process metallurgy

Hydrogen-driven routes to steel from siderite with low CO 2 emissions: A modeling study

Numerical Simulation Study of Co-injection of Pulverized Coal and Hydrogen in the Tuyere-Raceway

Direct reduction of iron-ore with hydrogen in fluidized beds: A coarse-grained CFD-DEM-IBM study

Numerical Simulation of the Effect of Feeding Mode on the Reduction of Ore Powder in Hydrogen‐Based Flash Ironmaking Process

Computational Study of Hot Gas Injection (HGI) into an Ironmaking Blast Furnace (BF)

Numerical Simulation of Dehydrogenation Annealing in Bloom

Detailed Modeling of the Direct Reduction of Iron Ore in a Shaft Furnace

The carbon reduction potential of hydrogen in the low carbon transition of the iron and steel industry: The case of China

Study on the reduction of Fe2O3 pellets by CO-CO2 and H2-H2O: Reaction kinetics and pore network model