Abstract:Long-Period Stacking Ordered (LPSO) phases in the Mg-Y-Zn alloys can significantly improve comprehensive mechanical properties of the Mg-based alloys. The nominal compositions of the Mg95Y3Zn2 and Mg86Y8Zn6 (at%) alloys with different contents of LPSO phases were tailored by CALPHAD method, and the tested compositions of these two alloys were Mg95.2Y2.6Zn2.2 and Mg86.2Y7.7Zn6.1, respectively. The microstructure evolutions of the studied alloys in the states of as-cast and isothermal treatments at different times were observed, and the mechanical properties of the as-extruded alloys after homogenization (short term, 12 h) and the isothermal treatment (long term, 240 h) at 500 & DEG;C were measured. After the isothermal treatment at 500 degrees C for 240 h, the phase constituent of the Mg95.2Y2.6Zn2.2 alloy changed from the as-cast three phases (18 R + & alpha;-Mg + W-Mg3Y2Zn3) into the equilibrium three phases (18 R + & alpha;-Mg + 14 H), while that of the Mg86.2Y7.7Zn6.1 alloy completely changed from the as-cast four phases (18 R + & alpha;-Mg + W-Mg3Y2Zn3 + 14 H) into the equilibrium two LPSO phases (18 R + 14 H), where the 14 H-type LPSO phase is formed by the four-phase invariant reaction of "18 R + & alpha;-Mg + WMg3Y2Zn3 -* 14 H" at 546 & DEG;C and the three-phase univariant reaction of "18 R + & alpha;-Mg -* 14 H" below 546 & DEG;C. The results of mechanical properties show that the yield strength of the Mg86.2Y7.7Zn6.1 alloy composed entirely of LPSO phases is better than that of the Mg95.2Y2.6Zn2.2 alloy composed of both LPSO phases and some & alpha;-Mg matrix, while the plasticity of the Mg86.2Y7.7Zn6.1 alloy is not as good as that of the Mg95.2Y2.6Zn2.2 alloy. Therefore, the amount of LPSO phases can be increased for pursuing high strength of Mg alloys, but a certain amount of & alpha;-Mg phase needs to be kept for retaining good plasticity. For this purpose, the alloy composition with a specific amount of the LPSO phases and & alpha;-Mg matrix in the Mg-Y-Zn system can be tailored by CALPHAD method.

Effect of long period stacking ordered structure on the biocorrosion resistance and osteogenesis ability of Mg–Zn–Y-Mn alloys

Effect of the Morphology of Long-Period Stacking Ordered Phase on Mechanical Properties and Corrosion Behavior of Cast Mg-Zn-Y-Ti Alloy

Microstructure characterization and corrosion behavior of Mg–Y–Zn alloys with different long period stacking ordered structures

Effect of Volume Fraction of LPSO Phases on Corrosion and Mechanical Properties of Mg-Zn-Y Alloys

Corrosion Behaviors of Long‐Period Stacking Ordered Structure in Mg Alloys Used in Biomaterials: A Review

Modification of Mn on Corrosion and Mechanical Behavior of Biodegradable Mg88Y4Zn2Li5 Alloy with Long-Period Stacking Ordered Structure

The Effect of Rod-Shaped Long-Period Stacking Ordered Phases Evolution on Corrosion Behavior of Mg 95.33 Zn₂Y 2.67 Alloy.

Effects of Li on Microstructures, Mechanical, and Biocorrosion Properties of Biodegradable Mg94‐xZn2Y4Lix Alloys with Long Period Stacking Ordered Phase

Effect of Long-Period Stacking Ordered Phase on Microstructure, Mechanical Property and Corrosion Resistance of Mg Alloys: A Review

Biocorrosion Behavior and Cytotoxicity of a Mg–Gd–Zn–Zr Alloy with Long Period Stacking Ordered Structure

The Relation Between Microstructure and Corrosion Behavior of Mg-Gd-Zn Alloy with Long Period Stacking Ordered Structure

Microstructure Development and Biodegradation Behavior of Additively Manufactured Mg-Zn-Gd Alloy with LPSO Structure

Effect of morphology of long period stacking ordered phase on mechanical properties of Mg-10Gd-1Zn-0.5Zr magnesium alloy

Effect of Al-Sr master alloy on the formation of long period stacking ordered phase and mechanical properties of Mg-Gd-Zn alloy

Study of Mg–Gd–Zn–Zr Alloys with Long Period Stacking Ordered Structures

Effect on Zn on Microstructures and Mechanical Properties of Mg–Gd–Y–Zn LPSO Alloys

The Effect of Morphology of the Long-Period Stacking Ordered Phase on Mechanical Properties of the Mg-7Gd-3Y-1Nd-1Zn-0.5Zr (wt.%) Alloy

Effect of Alloying Elements on the Formation and Structural Features of Long Period Stacking Structures in As-Cast Mg Alloys

Role of the LPSO Structure in the Improvement of Corrosion Resistance of Mg-Gd-Zn-Zr Alloys

Experimental Study on the Microstructure and Mechanical Properties of the Mg-Y-Zn Alloys with LPSO Phases Tailored by CALPHAD Method

Mechanical Properties of the Mg-Gd-Y-Zn-Zr Alloys with Different Morphologies of Long-Period Stacking Ordered Phases