Impact of Annealing on Magnetic Properties and Structure of Co40Fe40W20 Thin Films on Si(100) Substrate
Wen-Jen Liu,Yung-Huang Chang,Yuan-Tsung Chen,Tian-Yi Jhou,Ying-Hsuan Chen,Te-Ho Wu,Po-Wei Chi
DOI: https://doi.org/10.3390/ma14113017
IF: 3.4
2021-06-02
Materials
Abstract:Co40Fe40W20 monolayers of different thicknesses were deposited on Si(100) substrates by DC magnetron sputtering, with Co40Fe40W20 thicknesses from 10 to 50 nm. Co40Fe40W20 thin films were annealed at three conditions (as-deposited, 250 °C, and 350 °C) for 1 h. The structural and magnetic properties were then examined by X-ray diffraction (XRD), low-frequency alternative-current magnetic susceptibility (χac), and an alternating-gradient magnetometer (AGM). The XRD results showed that the CoFe (110) peak was located at 2θ = 44.6°, but the metal oxide peaks appeared at 2θ = 38.3, 47.6, 54.5, and 56.3°, corresponding to Fe2O3 (320), WO3 (002), Co2O3 (422), and Co2O3 (511), respectively. The saturation magnetization (Ms) was calculated from the slope of the magnetization (M) versus the CoFeW thickness. The Ms values calculated in this manner were 648, 876, 874, and 801 emu/cm3 at the as-deposited condition and post-annealing conditions at 250, 350, and 400 °C, respectively. The maximum MS was about 874 emu/cm3 at a thickness of 50 nm following annealing at 350 °C. It indicated that the MS and the χac values rose as the CoFeW thin films’ thickness increased. Owing to the thermal disturbance, the MS and χac values of CoFeW thin films after annealing at 350 °C were comparatively higher than at other annealing temperatures. More importantly, the Co40Fe40W20 films exhibited a good thermal stability. Therefore, replacing the magnetic layer with a CoFeW film improves thermal stability and is beneficial for electrode and strain gauge applications.
materials science, multidisciplinary,chemistry, physical,physics, applied, condensed matter,metallurgy & metallurgical engineering