Abstract:Concrete reinforcement is essential for ensuring the safety and durability of concrete structures. Bonding steel plates to reinforce concrete is widely used to renovate or strengthen concrete beam structures. Due to construction quality and the influence of factors such as environment and fatigue, debonding often occurs between the steel plate and concrete, making monitoring and early warning after concrete structure reinforcement challenging. This paper proposes a novel approach to monitor the degree of debonding between the steel plate and concrete beam using active sensing technology. The method uses lead zirconate titanate (PZT) as an actuator to generate stress waves. It prepares strip sensors with polyvinylidene fluoride as the sensing element to monitor stress waves passing through the steel plate and concrete beam. The monitoring system detects the degree of debonding between the steel plate and the concrete beam by monitoring the change in surface voltage of the sensor. Experiments show that the degree of debonding significantly correlates with the received voltage signal; the higher the debonding, the larger the received voltage signal. It is also observed that, at the same degree of debonding, the actuator and sensor attachment position have a particular impact on the received voltage signal. Through experiments and numerical simulation analysis, it is found that when the sensor is attached to the left side of the steel plate, that is, the bonded section of the steel plate, the amplitude of the voltage signal collected by the dynamic information acquisition system is the smallest, i.e., V_debonded section > V_middle > V_bonded section. Based on the above research, the active sensing technology proposed in this paper has good sensitivity to the degree of debonding between the steel plate and concrete. It is expected to become an effective monitoring and evaluation method for the degree of debonding between steel plates and concrete.

Monitoring of the Bond State between the Concrete-Filled Steel Tube Pile and Surrounding Soil

Study on pile-soil bonding condition based on transient shock response using piezoceramic sensors

Self-sensing Joints for In-Situ Structural Health Monitoring of Composite Pipes: A Piezoresistive Behavior-Based Method

Field Trials on Monotonic Behaviour of a Driven Pile at an Offshore Wind Farm in China

Field monitoring for silence piling construction in deep soft soil foundation

Experimental study on axial compression monitoring of pile foundation based on sensor-enabled piezoelectric geocable

BOTDR Monitoring Analysis of Anti-Sliding Pile Internal Force

A Destructive Field Study on the Behavior of Pile under Ten

Field Test of Excess Pore Water Pressure at Pile–Soil Interface Caused by PHC Pipe Pile Penetration Based on Silicon Piezoresistive Sensor

Monitoring of Epoxy-Grouted Bonding Strength Development between an Anchored Steel Bar and Concrete Using PZT-Enabled Active Sensing

Study on the monitoring method of debonding between concrete beams and reinforced steel plates based on piezoelectric smart materials

Monitoring of Concrete Structure Damage Caused by Sulfate Attack with the Use of Embedded Piezoelectric Transducers

Study on Monitoring and Estimating Soil Physical Properties Using Piezoceramic Transducer

Monitoring and Analysis of Pore and Earth Pressure at the Pile Surface Using Piezoresistive Silicon Pressure Transducers

Field Monitoring of Bearing Capacity Efficiency of Permeable Pipe Pile in Clayey Soil: A Comparative Study

Interface Monitoring Of Steel-Concrete-Steel Sandwich Structures Using Piezoelectric Transducers

Piezoelectric-based non-destructive monitoring of hydration of reinforced concrete as an indicator of bond development at the steel–concrete interface

Damage Detection of L-Shaped Concrete Filled Steel Tube (L-CFST) Columns under Cyclic Loading Using Embedded Piezoceramic Transducers

Monitoring and quantification of non-uniform corrosion induced mass loss of steel piles with distributed optical fiber sensors

Detection of the debonding defect of concrete-filled steel tubes with piezoceramics

Crack Monitoring in Concrete Structures Based on Piezoelectric Impedance Technique