Abstract:Aiming at the problem of serious deviation from the actual energy consumption for the calculated energy consumption with the continuous operation mode prescribed in current design standard for residential building energy efficiency in hot summer and cold winter zone, a questionnaire survey for the use mode of air conditioner has been conducted in Hangzhou, a typical city in this climate zone. It was found that there widely exists intermittent energy consuming method in the residential buildings of this area. The air conditioning using behavior was affected by thermal feeling of human body. The greater the indoor air temperature deviates from the the human body comfort scope, the higher the air conditioning opening rate is. DeST was employed to calculate the annual energy consumption of the residential building with internal and external wall insulations under different occupant behaviors, and then the annual energy saving effects were analyzed. The results show that in continuous energy consuming method, the annual energy saving effect for external insulation is better than that for internal insulation;in intermittent energy consuming method without considering tolerate temperature, the annual energy saving effect for internal insulation is better than that for external insulation. Under the condition of variable tolerate temperature, the critical tolerate temperature point for internal and external insulation with the same energy saving effect is 31.8 ℃ in summer and 13.4 ℃ in winter. When tolerate temperature is lower than the critical point, the internal insulation has better energy saving effect; when tolerate temperature is higher than the critical point, the external insulation has better energy saving effect. The choice of reasonable insulation means in this region was greatly affected by the air?conditioning behaviors and occupants’ thermal tolerance. The critical tolerate temperature for the same energy saving of the internal and external insulations is 31.8℃ in summer and 13.4℃ in winter. Therefore, setting reasonable air?conditioning behavior in the design standard for energy efficiency is an important premise for accurately evaluating the energy saving effect of exterior wall insulation measures.

Reducing the cost of energy used for adaptation by using different exterior wall covering materials in Iraq

Reducing heat gain from sheet metal‐clad walls by utilizing industrially wasted materials (experimental study)

Influence on energy saving effects of internal and external wall insulations for different occupant behaviors

Anti-insulation Behavior for Exterior Wall External Insulation on Residential Buildings in Hot Summer and Cold Winter Zone

The Energy Saving Effect of Different Wall Insulation Configurations with the Intermittent and Compartmental Heating Method

Performance and Economical Analysis of Different Insulating Materials Used to Reduce the Heat Load of an Existing Residential Building

Case studies on energy performance of walling materials in various regions

Passive Building Energy Saving: Building Envelope Retrofitting Measures to Reduce Cooling Requirements for a Residential Building in an Arid Climate

Numerical investigation of the thermal behaviour of external multilayer walls to ensure the buildings retrofitting thermal insulation

Energy optimization for Façade retrofit design of residential buildings in hot climates using advanced materials

Dynamic insulation technology in buildings subject to intermittent heating and cooling, part a, iraqi case

Thermal performance and energy saving using phase change materials (PCM) integrated in building walls

Heat transfer reduction in buildings by embedding phase change material in multi-layer walls: Effects of repositioning, thermophysical properties and thickness of PCM

Retrofitting Building Envelope Using Phase Change Materials and Aerogel Render for Adaptation to Extreme Heatwave: A Multi-Objective Analysis Considering Heat Stress, Energy, Environment, and Cost

A comparative evaluation on energy consumption of a building using bio-based and paraffin-based phase change materials integrated to external building envelope

Development of a Novel Low-Energy Building: Effects of Room Orientation and Wall Materials

Competition between insulation and phase change material to intensify the resilience of envelope against heat exchange to reduce overall energy consumption in buildings

Thermal Energy Shifting Using Thermal Energy Storage with Solar Assisted System for Space Cooling Application

Innovative passive techniques and PCM integration in building envelopes for enhanced energy efficiency in desert regions

Optimising Window-to-Wall Ratio for Enhanced Energy Efficiency and Building Intelligence in Hot Summer Mediterranean Climates

The impact of window orientation, glazing, and window-to-wall ratio on the heating and cooling energy of an office building: The case of hot and semi-arid climate