Abstract:A study on combined manual materials-handling tasks performed on floors under three friction levels was conducted. Eight male subjects participated in the study. The maximum acceptable weight of handling, including lifting. carrying for 3 in, lowering, and walking 3 m back at twice per minute was determined. The subject then performed the same tasks for 10 min. Heart rate, Vo(2), energy efficiency, perceived sense of slip, and rating of perceived exertion for whole body strain were measured. The results showed that the effects of friction level on the maximum acceptable weights of handling, perceived sense of slip, Vo(2),, and energy efficiency were statistically significant (p <= 0.0006). As the friction level increased from low to high, the maximum acceptable weights of handling increased from 8.15 to 9.34 kg. The energy efficiency on the low friction condition (12.58 kg/L/min) was significantly lower than those of the medium (15.73 kg/L/min) and high (15.38 kg/L/min) friction conditions. The perceived sense of slip was the highest (5.44) on the low-friction condition, followed by the medium-friction condition (3.58), and last the high-friction condition (1.84). The implication of this study was that friction level should be regarded as one of the major environmental factors in designing MMH tasks as it affected both physiological and psychophysical responses of the Subjects. Low-friction footwear-floor interface should be avoided as it resulted in not only high scores of perceived sense of slip but also in low-energy efficiency utilized in the body. (c) 2006 Elsevier Ltd. All rights reserved.

Determination of The Static Friction Coefficient of Some Materials Used for Anti-slip Safety with ANOVA

The Experimental Study of Slip - Resistance of Existing Floors on a College Campus

A Novel Method for Evaluating the Effectiveness of Shoe-Tread Designs Relevant to Slip and Fall Accidents

Investigation of Prosthetic Feet Friction for Enhanced Stability in Persons With Disabilities: ANFIS Analysis of Rubber-Floor Interaction

A field assessment of floor slipperiness in a student cafeteria.

Friction Between Footwear And Floor Covered With Solid Particles Under Dry And Wet Conditions

The effect of surface roughness and contaminant on the dynamic friction of porcelain tile

The Calculation of Kinetic and Static Friction Coefficient and Friction Graph Analysis Using Arduino

Tribological Analysis of Surface Textures in Porcelain Tiles for Enhancing Pedestrian Walkway Safety

Perceived floor slipperiness and floor roughness in a gait experiment.

A Novel Signal Processing Method for Friction and Sliding Wear

Experimental Study on Slip Resistant Behaviours of Aluminium Alloy-Stainless Steel Faying Surfaces

Investigation the yarn to yarn static and kinetic friction based on the response surface method

Physiological and Psychophysical Responses in Handling Maximum Acceptable Weights under Different Footwear–floor Friction Conditions

Experimental study on tribological properties of PTFE and glass reinforced PTFE-C15 for skid transport of heavy structures

The influence of footwear tread groove parameters on available friction

Recent Progress on Anti-Slip and Highly Wear-Resistant Elastic Coatings: An Overview

Required Coefficient of Friction Versus Top-Piece/Outsole Hardness and Walking Speed: Significance of Correlations

Prospective validity assessment of a friction prediction model based on tread outsole features of slip-resistant shoes

Friction Analysis of Anisotropic Surface for Viscoelastic Material