Abstract:The objective of this work is to present an integral methodology to numerically model the wear phenomena by friction in a polymer–metal contact pair, showing the development of a numerical tool to implement a wear model in the commercial finite element code Abaqus. The contact pair in which this work is based corresponds to the contact between a guide shoe insert for an elevator, made of thermoplastic polyurethane elastomers (TPU), and the corresponding guide, made of steel. Tribometer tests are planned to fit the numerically implemented wear model as well as to validate it. These tests are briefly described as an introduction to the numerical fitting of the data from which the wear model is obtained. The numerical tool in which the wear model in a polymer–steel contact pair is implemented is based on a methodology that combines the use of the user subroutine Umeshmotion, which offers the possibility of implementing a wear model in any general form, several routines to result access, and the adaptive meshing technique, a mesh smoothing tool available in Abaqus based on ALE (Augmented Lagrangian Eulerian) methods. With this technique, it is possible to eliminate material during the simulation as well as to maintain a high-quality mesh throughout an analysis by allowing the mesh to move independently of the material. As the tests that are carried out in the tribometer to fit and to validate the wear model require long travel distances and a large number of cycles, a real simulation of those tests would require a huge calculation time. Therefore, to simulate the wear process equivalent to the travelled distances in the tests in an affordable simulation time, an accelerated numerical procedure of the wear process is also proposed in this work. To numerically implement the wear model, and as it is usually stated in polymers, it is previously necessary to set up a procedure for determining the relationship between the friction coefficient and the contact pressure for the material and countermaterial contact pair. Finally, a validation of the methodology with a new wear tribometer test under different conditions to those stated to characterise the model is also presented.

A Novel Signal Processing Method for Friction and Sliding Wear

A Time-Frequency Based Approach for Acoustic Emission Assessment of Sliding Wear

A Study of Sliding Friction Using an Acoustic Emission and Wavelet-Based Energy Approach

Predicting the coefficient of friction in a sliding contact by applying machine learning to acoustic emission data

Prediction of frictional behaviour through regression equations: A statistical modelling approach validated with machine learning

Evaluation of Wear of Disc Brake Friction Linings and the Variability of the Friction Coefficient on the Basis of Vibroacoustic Signals

Estimation of Road Friction Coefficient in Different Road Conditions Based on Vehicle Braking Dynamics

A Technique for Measuring Dynamic Friction Coefficient under Impact Loading

Kalker's algorithm Fastsim solves tangential contact problems with slip-dependent friction and friction anisotropy

A Comprehensive Experimental Study and Numerical Analysis of Coefficient of Friction of Nanocomposite Coatings

Estimation of Tire-Road Friction Coefficient Based on Combined Apf-Iekf and Iteration Algorithm

A correlation analysis method for analyzing tribological states using acoustic emission, frictional coefficient, and contact resistance signals

Prediction of Friction Power via Machine Learning of Acoustic Emissions from a Ring-on-Disc Rotary Tribometer

A machine learning approach for determination of coefficient of friction from ring compression test

Frictional Characteristic Curves of Ground Surfaces in Lubricated Sliding

Triboinformatic modeling of dry friction and wear of aluminum base alloys using machine learning algorithms

Wear Characterization under Sliding–rolling Contact Using Friction-Induced Vibration Features

Finite element implementation and validation of wear modelling in sliding polymer–metal contacts

A Simulation Method of Thermo-Mechanical and Tribological Coupled Analysis in Dry Sliding Systems

On-board road condition monitoring system using slip-based tyre-road friction estimation and wheel speed signal analysis

Finite element analysis of fretting wear considering variable coefficient of friction