Abstract:This paper presents a numerical approach to simulate sliding friction between engineering surfaces with 3D roughness in point contacts. The numerical approach is developed on the basis of the deterministic solutions of mixed lubrication, which is able to predict the locations where the asperity contacts occur, and the pressure distribution over both lubrication and contact areas. If the friction coefficients over the contacting asperities have been determined, total friction force between the surfaces can be calculated by summing up the two components, i.e., the boundary friction contributed by contacting asperities and the shear stress in hydrodynamic regions. The fi-ictions from asperity contact were determined in terms of a limiting shear stress or shearstrength of boundary, films while the fluid shear stress in the lubrication areas was calculated using different rheology models for the lubricant, in order to find which one would be more reliable in predicting fluid tractions. The simulations covered the entire lubrication, regime, including full-film Elastohydrodynamic Lubrication (EHL), mixed lubrication, and boundary lubrication. The results, when being plotted as a function of sliding velocity, give a Stribeck-type friction curve. This provides an opportunity to study friction change during the transition of lubrication conditions and to compare friction performance oil different rough surpces, which is of great value in engineering practice. Experiments were conducted on a commercial test device-universal material tester (UMT) to measure friction at a fixed load but different sliding velocities in reciprocal or rotary motions. The results also give rise to the Stribeck friction curvesfor different rough surfaces, which are to be compared with the results from simulations. The samples were prepared with typical machined surfaces in different roughness heights and textures, and in point contacts with steel ball. Results show that there is a general agreement between the experiments and simulations. It is found that surface features, such as roughness amplitude and patterns, may have a significant effect on the critical speed of transition firom hydrodynamic to mixed lubrication. It? the regime of mixed lubrication, rougher samples would give rise to a higherfiriction if the operation conditions are the same.

A Simulation Method of Thermo-Mechanical and Tribological Coupled Analysis in Dry Sliding Systems

Analyzing Performance of Automobile Brake Drum in 3D Thermo-elastic Coupling Field

Heat Analysis of Sliding Abrasive Particle Micro Contact Process by Finite Element Method

Numerical and Experimental Research on Engagement Process of Wet Multi-Plate Friction Clutches with Groove Consideration

Study on Simulation of Coupled Heat Transfer, Stress and Wear Behavior in Pin-on-disc Experiments

The Simulation Analysis of Thermo-Mechanical Coupled Stress for Wet Clutch Friction Plate Based on ABAQUS

Numerical Simulation of the Stress, Temperature & Wear Behaviors of the Drum Brake

Numerical simulation on the coupling behavior between thermal load, contact stress and wear in a disc brake

Numerical Investigation on Thermo Mechanical Behavior in Wet Multidisc Friction Pairs System

Sliding State Analysis of Fractal Rough Interface Based on the Finite Element Method

A Review of Dynamic-Tribological Simulation Methods for Sliding Bearings in Internal Combustion Engines

Notice of Removal: Numerical Simulation of the Stress, Temperature & Wear Behaviors of the Drum Brake

Thermomechanical Coupling Simulation and Analysis of Wet Multi-Disc Brakes During Emergency Braking

Experimental and Finite Element Analysis of Frictional Heat Distribution during Sliding Friction

Simulation of Sliding Wear in Mixed Lubrication

Simulation of the Friction Temperature Field for Disc Brake

Frictional heat accumulation at cyclically rolling-sliding contacts with consideration to time-dependent contact pressure

Simulations And Measurements Of Sliding Friction Between Rough Surfaces In Point Contacts: From Ehl To Boundary Lubrication

A thermomechanical model for the analysis of disc brake using the finite element method in frictional contact

Finite element modelling of frictional thermomechanical rolling/sliding contact using an arbitrary Lagrangian–Eulerian formulation

Investigation of thermal behavior of a novel multi-conical friction pair during wet clutch's engagement based on finite difference method