Abstract:Adsorption is an appealing technology for the removing of CO 2 from natural gas because it can handle high CO 2 concentrations at high pressures. The determination of mono-component breakthrough curves provides heat and mass transfer parameters to assess separation effectiveness that can be used for simulation of swing adsorption separation processes (PSA, TSA etc.). However, in lab-scale fixed-bed adsorption, it may be challenging to perform this assessment due to low flow conditions that are usually employed, affecting the flow regimedepending on the operation conditions. In this sense, this work aimed to evaluate the effect of flow regime configurations and difference in gases densities by means of residence time distribution (RTD) analysis in the PSA of CO 2 in a NaY zeolite fixed bed , in order to to collect information that satisfy pipeline specifications in industrial applications. A high-pressure lab-scale apparatus was used with NaY particles of 0.7250 mm mean diameter, a 10.5 cm bed height , and a tubular column of 2.0 cm internal diameter. The upward and downward flows were conducted under 528.82 ± 4.59 NmL min −1 inlet mass flow rate, 51 bar, and 30 °C. The RTD analysis was performed to verify the flow regime, and mass transfer zone (MTZ) length was estimated. It was observed that downward flow conditions promoted higher concentration spread than upward flow. RTD analysis showed that downward flow is dominated by laminar convection while the upward flow is dominated by dispersion. MTZ length increased from 0.64 cm in upward flow to 5.81 cm in downward flow. Therefore, assessing CO 2 flow conditions and, additionally, the difference in gases densities, are important steps that should be taken when dealing with fluid adsorption under high pressure because different densities between fluid components severely changed and affected flow regime and, consequently, separation effectiveness.

Breakthrough analysis of continuous fixed-bed dehydration of gas streams using 4A zeolite molecular sieve

Comparison of upward and downward flow in high-pressure bulk CO 2 gas adsorption on NaY zeolite fixed bed

Combined Grand Canonical Monte Carlo and Finite Volume Method Simulation Method for Investigation of Direct Air Capture of Low Concentration CO2 by 5A Zeolite Adsorbent Bed

Adsorption-absorption technique for effective CO2 capture

Modelling and simulation of water vapor adsorption in silica gel bidisperse beds

Evaluation of CO2 Adsorption Parameters in Fluidised Zeolite 13X Beds Using Non-Linear Multivariate Optimisation

Adsorption and recovery of low concentration coal-bed methane by zeolite ZSM-5

Experimental investigation of CO2 separation by adsorption methods in natural gas purification

CO2 capture by ethanolamines functionalized resins: amination and kinetics of adsorption in a fixed bed

Effect of K/Na ratio on adsorption of sweeted gas in dehydration packed bed adsorber; A Monte Carlo simulation study of single and multicomponent gas mixture

A Combined Gcmc And Fvm Simulation Method For Co2 Adsorption In 13x Zeolite Adsorption Bed

Performance Evaluation of Static and Dynamic CO2 Adsorption from Synthetic Gas Condensates Using Zinc Oxide, Silicon Dioxide and Zeolite 13X

Screening Zeolites for Gas Separation Applications Involving Methane, Nitrogen, and Carbon Dioxide

Adsorption and Desorption of Carbon Dioxide and Nitrogen on Zeolite 5A

Adsorptive Drying of Liquid Mixtures Containing Formaldehyde, Methanol, Water, and Poly(oxymethylene) Dimethyl Ethers on Zeolite 3A

One-Dimensional Formulation for Heat and Mass Transfer in Solid Desiccant Dehydration of Natural Gas

Adsorption of nitrogen oxides by the moisture-saturated zeolites in gas stream.

Experiment research on CO2 continuous capture using dual fluidized bed reactors with supported amine

Continuous CO2 Capture in Dual Fluidized Beds Using Silica Supported Amine

CO2 Physisorption over an Industrial Molecular Sieve Zeolite: An Experimental and Theoretical Approach

High-pressure adsorption of H2S, CO2 and CH4 on porous aromatic framework (PAF-30) at different temperatures