Abstract:Carbon fiber–reinforced plastics are now widely used in various industries because of its excellent properties. Although milling and drilling are the dominating processing methods for carbon fiber–reinforced plastics at present, laser beam machining, as a wear-free, contactless and flexible process, is considered a promising alternative method. However, the thermal damage is one of the most important issues for laser beam machining of carbon fiber–reinforced plastics because of the significant difference in thermal properties of carbon fiber and matrix. Water jet–guided laser technique has been proved an effective technique to reduce heat damage. Nevertheless, there are few studies about carbon fiber–reinforced plastics processing with water jet–guided laser to date. It is important to understand the mechanism of interaction between water jet–guided laser and carbon fiber–reinforced plastics. Hence, a three-dimensional finite element model was developed to investigate the transient thermal process. The influence of scanning speed on the surface appearance, heat-affected zone and shape of the cross section was illustrated. Experiments with same process parameters were conducted to validate the model. Based on the finite element model and experiments, the mechanism of material removal was explained. The epoxy is considered to be removed once it reaches the melting point and the carbon fiber is removed at the sublimation temperature. Because of the strong cooling effect of water jet, there is nearly no heat accumulation between pulses, leading to the constant heat-affected zone width at different scanning speed. The kerf sidewall is relatively vertical due to the homogeneous power distribution in water jet. The results demonstrate that water jet–guided laser cutting of carbon fiber–reinforced plastics has some advantages than traditional laser beam machining and is a potential processing method for carbon fiber–reinforced plastics.

Study on the mechanism of quasi-continuous wave (QCW) fiber laser low-damage processing of carbon fiber-reinforced plastics

Experimental study on gas-assisted laser cutting carbon fiber reinforced plastics

Analysis and optimization of the heat affected zone of CFRP by femtosecond laser processing

Grooving of CFRP with water mist jet–assisted nanosecond pulsed laser: effect of process parameters on removal mechanisms and HAZ formation

Study on mechanism of spray-mist-assisted laser processing of carbon fiber reinforced plastic

Investigation on mechanism for water-gas jet-assisted laser processing of carbon fiber-reinforced polymer

Study on anisotropic heat transfer and thermal damage in nanosecond pulsed laser processing of CFRP

Study on Laser Cutting Carbon Fibre Reinforced Composites

Development of Laser Processing Carbon-Fiber-Reinforced Plastic

Research progress on laser processing of carbon fiber-reinforced composites

Surface Integrity of Water Jet Guided Laser Machining of CFRP

Research progress on the quality and efficiency of carbon fiber reinforced thermoplastic polymer composites processed by laser

Homogeneous Removal of Heterogeneous CFRP Composite Via Aluminum/polyimide Laminate Assisted Femtosecond Laser Processing

Study on HAZ extension characteristics during laser ablation of CFRP based on dimensional analysis

Research Progress on Laser Processing of Carbon Fiber Composite Materials

Study on the control and mechanism of balance between heat and cold for spray-mist-assisted laser processing of CFRP

Study on the mechanism of ultrasonic-assisted laser processing carbon fiber reinforced plastics in ethanol solution

Investigation on heat transfer and ablation mechanism of CFRP by different laser scanning directions

The Experimental Investigation of Water Jet–guided Laser Cutting of CFRP

Study on the CFRP nanosecond laser cutting damage and efficiency by aspiration system assisted method

Numerical Simulation of Water Jet–guided Laser Cutting of Carbon Fiber–reinforced Plastics