Abstract:Carbon fiber reinforced plastics (CFRP) has been widely used in aerospace, military weapons, new energy and high-end vehicles due to its specific and superior strength, low density and long-lasting wear resistance. The processing of CFRP is very different from the traditional metal processing because of its heterogeneous structure, anisotropy and superior wear resistance of CFRP. Usually, CFRP has often various defects in mechanical processing and water jet processing, such as interlayer tearing, fiber pull-out, delamination, tool wear, and abrasive penetration. Through laser processing, the problems of CFRP materials existing in mechanical processing can be overcome. However, due to the huge differences in thermal physical properties such as thermal conductivity and vaporization temperature of carbon fiber and resin in CFRP, its laser processing also turns out to have some issues, such as heat-affected zone and fiber end expansion. This paper summarizes the research results of CFRP laser processing in China and internationally. Research progress was introduced in detail from various aspects including laser and material mechanism as well as laser processing parameters. It reports the experimental and theoretical studies covering the process accuracy in edge quality and the thermal characteristics in terms of heat-affected zone. Eliminating the heat-affected zone in the polymer matrix are considered the major obstacles of CFRP industrial applications. The methods of improving processing efficiency by increasing material removal rate and reducing processing time were reviewed. The influence of different thermal conductivity of carbon fiber and resin matrix in CFRP on the processing quality was discussed. Finally, the development trend and challenges of thermal conductivity of carbon fiber and resin in CFRP in theoretical modeling were proposed.

Research progress on laser processing of carbon fiber-reinforced composites

Research progress on the quality and efficiency of carbon fiber reinforced thermoplastic polymer composites processed by laser

Research Progress on Laser Processing of Carbon Fiber Composite Materials

Development of Laser Processing Carbon-Fiber-Reinforced Plastic

A Review of Research Progress on Machining Carbon Fiber-Reinforced Composites with Lasers

Study on the mechanism of quasi-continuous wave (QCW) fiber laser low-damage processing of carbon fiber-reinforced plastics

Investigation on mechanism for water-gas jet-assisted laser processing of carbon fiber-reinforced polymer

Study on Laser Cutting Carbon Fibre Reinforced Composites

Investigations on 355 nm picosecond laser machining of carbon fiber reinforced polymer composites

Investigation on heat transfer and ablation mechanism of CFRP by different laser scanning directions

Study on anisotropic heat transfer and thermal damage in nanosecond pulsed laser processing of CFRP

Surface Integrity of Water Jet Guided Laser Machining of CFRP

Investigation of Heat Accumulation in Femtosecond Laser Drilling of Carbon Fiber-Reinforced Polymer

Analysis and optimization of the heat affected zone of CFRP by femtosecond laser processing

Mechanical Enhancement of Carbon Fiber-Reinforced Polymers: from Interfacial Regulating Strategies to Advanced Processing Technologies

Experimental Study on Carbon Fiber-Reinforced Composites Cutting with Nanosecond Laser

Homogeneous Removal of Heterogeneous CFRP Composite Via Aluminum/polyimide Laminate Assisted Femtosecond Laser Processing

Development of Curing Process for Fiber-reinforced Resin Matrix Composites

Study on UV Laser Cutting Carbon Fibre Reinforced Composites

Experimental Evaluation of Cutting Quality of Carbon Fibre Reinforced Polymer with Pulsed Laser

Ablation behaviors of carbon reinforced polymer composites by laser of different operation modes