Abstract:Mechanism analysis, process optimisation and validation of laser surface treatment. Adhesive bonding has gradually replaced mechanical connections as the primary method for composite material bonding, with surface quality being the key factor determining the effectiveness of composite material adhesion. Laser surface treatment, known for its green and precise characteristics, has garnered widespread attention from both academia and industry. However, the process parameters of laser surface treatment are complex, efficiency is low, and the mechanism remains unclear. This paper, based on the response surface methodology (RSM), investigates the influence of laser secondary parameters on the resin removal rate of carbon fiber reinforced polymer/plastic (CFRP) surfaces and the impact of defocusing on surface treatment efficiency. The results indicate that when the total laser energy density (Et) is 69 J/cm2, the overlap ratio in the warp direction (OLs) is 76%, and the overlap ratio in the weft direction (OLh) is 85%, the surface tensile shear strength increases by 90.59% and 27.77% compared to the original surface and polished surface, respectively. When the defocus distance is +8 mm, the efficiency of laser surface treatment is 2.25 times that of non‐defocus, with minimal impact on mechanical performance. The surface treatment mechanism, with changes in Et, primarily involves the pure thermal decomposition of the resin matrix in an oxygen‐free environment, oxidative decomposition, and the synergistic action of the decomposition products' oxidation. Through the coupled optimization of laser process parameters, this work enhances the efficiency and effectiveness of composite material adhesive surface treatment, promoting the engineering application of laser technology. Highlights By establishing a response surface model, the study elucidated the impact patterns of laser secondary parameters (overlap rates in the warp and weft directions, total energy density) on the resin removal rate of CFRP surfaces. Based on the laser surface treatment phenomena at different total energy densities, the study analyzed and revealed the mechanism of near‐infrared (1064 nm) laser resin removal from CFRP surfaces. By increasing the spot size through defocusing, the efficiency of laser surface treatment was enhanced, and the impact on the interfacial properties of CFRP after defocused treatment was validated.

Study on the control and mechanism of balance between heat and cold for spray-mist-assisted laser processing of CFRP

Study on mechanism of spray-mist-assisted laser processing of carbon fiber reinforced plastic

Grooving of CFRP with water mist jet–assisted nanosecond pulsed laser: effect of process parameters on removal mechanisms and HAZ formation

Investigation on mechanism for water-gas jet-assisted laser processing of carbon fiber-reinforced polymer

Study on the mechanism of quasi-continuous wave (QCW) fiber laser low-damage processing of carbon fiber-reinforced plastics

Investigation on heat transfer and ablation mechanism of CFRP by different laser scanning directions

Analysis and optimization of the heat affected zone of CFRP by femtosecond laser processing

Surface Integrity of Water Jet Guided Laser Machining of CFRP

Study on HAZ extension characteristics during laser ablation of CFRP based on dimensional analysis

Research progress on laser processing of carbon fiber-reinforced composites

Study on anisotropic heat transfer and thermal damage in nanosecond pulsed laser processing of CFRP

Study on the mechanism of ultrasonic-assisted laser processing carbon fiber reinforced plastics in ethanol solution

Interactional relations between ablation and heat affected zone (HAZ) in laser cutting of glass fiber reinforced polymer (GFRP) composite by fiber laser

The Experimental Investigation of Water Jet–guided Laser Cutting of CFRP

Investigation of Heat Accumulation in Femtosecond Laser Drilling of Carbon Fiber-Reinforced Polymer

Research progress on the quality and efficiency of carbon fiber reinforced thermoplastic polymer composites processed by laser

Process optimization and performance verification of CFRP laser surface modification

Investigation on ablative process of CFRP laminates under laser irradiations

Reducing the taper and the heat-affected zone of CFRP plate by Micro fluid assisted laser induced plasma micro-drilling

Numerical Simulation of Water Jet–guided Laser Cutting of Carbon Fiber–reinforced Plastics

Numerical simulation of paint stripping on CFRP by pulsed laser