Abstract:This paper studies control strategies for an AC/AC system based on a modular multilevel matrix converter (M3C) when an asymmetric fault occurs in the secondary side ac system. Firstly, the operating principle of M3C is briefly introduced and verified by simulation. Then, based on its mathematical model by double αβ0 transformation, the decoupled control strategies for the primary side and secondary side systems are designed. In view of the asymmetric fault condition of the secondary side system, the positive sequence and negative sequence components of voltages and currents are separated and extracted, and then a proportional resonant controller (PR) is used to regulate the positive and negative sequence currents at the same time to realize decoupled current control in the αβ reference frames. The capacitor voltage balancing control, which consists of an inter-subconverter balancing control and an inner-subconverter balancing control, is realized by adjusting four circulating currents. Finally, the proposed control strategy is validated by simulation in the PSCAD/EMTDC software (Manitoba HVDC Research Center, Canada). The result shows that during the period of the BC-phase short-circuit fault occurring in the secondary side system, the whole system can still operate stably and transmit a certain amount of active power, according to their set values. Furthermore, the capacitor voltages are balanced, with a slight increase during the fault period. The simulation results verify the effectiveness of the proposed control strategy.

Fault Detection and Identification Strategy Based on Luenberger Observer for Bidirectional Interleaved Switched—Capacitor DC–DC Converter Interfaced Microgrids

An Observer-Based Switch Open-Circuit Fault Diagnosis of DC-DC Converter for Fuel Cell Application

Online Fault Identification Based on an Adaptive Observer for Modular Multilevel Converters Applied to Wind Power Generation Systems

A Global State Observer-Based Open-Switch Fault Diagnosis for Bidirectional DC-DC Converters in Hybrid Energy Source System

L- and LCL-Filtered Grid-Tied Single-Phase Inverter Transistor Open-Circuit Fault Diagnosis Based on Post-Fault Reconfiguration Algorithms

A Novel Observer-Centric Approach for Detecting Faults in Islanded AC Microgrids with Uncertainties

Comprehensive Analysis and Reconstruction of Sensor Faults in Interleaved Buck Converters Using Sliding Mode Observers

Open-Circuit Switch Fault Diagnosis and Fault- Tolerant Control for Output-Series Interleaved Boost DC–DC Converter

Detection and Isolation of Multiple Faults in a Modular Multilevel Converter Based on a Sliding Mode Observer

Fault diagnosis scheme for open-circuit faults in switched reluctance motor drives using fast Fourier transform algorithm with bus current detection

A Multi-Modular Shunt Active Power Filter System and Its Novel Fault-Tolerant Strategy Based on Split-Phase Control and Real-Time Bus Communication.

Robust Open-Circuit Fault Diagnosis of Multi-Phase Floating Interleaved DC–DC Boost Converter Based on Sliding Mode Observer

A Simultaneous Diagnosis Approach for Power Switch, Grid-Side Current Sensor, and DC-Link Voltage Sensor Faults in Single-Phase Three-Level Rectifiers

Research on an Asymmetric Fault Control Strategy for an AC/AC System Based on a Modular Multilevel Matrix Converter

Open-circuit Fault Detection and Isolation for Modular Multilevel Converter Based on Sliding Mode Observer

A novel fault-tolerant Shunt Active Power Filter and its control strategy

A Novel Fault-Tolerant Control Scheme for Shunt Active Power Filter with High Reliability

Dynamic State Estimation Enabled Health Indicator for Parametric Fault Detection in Switching Power Converters

Detection and Identification of Power Switch Failures Using Discrete Fourier Transform for DC–DC Flying Capacitor Buck Converters

Strong Tracking Filter Based Switching Converter Fault Diagnosis

A Fault-Tolerant Bidirectional Converter for Battery Energy Storage Systems in DC Microgrids