Abstract:Due to the possibility of putting a large number of modules consisting of switches and capacitors connected in series, the modular multilevel converter (MMC) can easily be scaled to high power and high voltage power conversion, which is an attractive feature for filter-less and transformer-less design and helpful to achieve high efficiency. However, a significantly increased amount of sub-modules in a MMC may increase the requirements for sensors and also increase the risk of failures. As a result, fault detection and diagnosis of MMC sub-modules are of great importance for continuous operation and post-fault maintenance. Therefore, in this paper, an effective fault diagnosis technique for real-time diagnosis of the switching device faults covering both the open-circuit faults and the short-circuit faults in MMC sub-modules is proposed, in which the faulty phase and the fault type is detected by analyzing the difference among the three output load currents, while the localization of the faulty switches is achieved by comparing the estimation results by the adaptive observer. In contrast to other methods that use additional sensors or devices, the presented technique uses the measured phase currents only, which are already available for MMC control. In additional, its operation, effectiveness and robustness are confirmed by simulation results under different operating conditions and load conditions.

Open-circuit Fault Detection and Isolation for Modular Multilevel Converter Based on Sliding Mode Observer

Robustness Analysis and Experimental Validation of a Fault Detection and Isolation Method for the Modular Multilevel Converter

Detection and Isolation of Multiple Faults in a Modular Multilevel Converter Based on a Sliding Mode Observer

A Voltage-Based Open-Circuit Fault Detection and Isolation Approach for Modular Multilevel Converters With Model-Predictive Control

Submodule Open-Circuit Fault Detection For Modular Multilevel Converters Under Light Load Condition With Rearranged Bleeding Resistor Circuit

Online Fault Identification Based on an Adaptive Observer for Modular Multilevel Converters Applied to Wind Power Generation Systems

Robust Open-Circuit Fault Diagnosis of Multi-Phase Floating Interleaved DC–DC Boost Converter Based on Sliding Mode Observer

Switch Open-Circuit Fault Detection and Localization for Modular Multilevel Converters Based on Signal Synthesis

The Fault Detection, Localization, and Tolerant Operation of Modular Multilevel Converters with an Insulated Gate Bipolar Transistor (IGBT) Open Circuit Fault

Survey of Switch Fault Diagnosis for Modular Multilevel Converter

Submodule Fault Detection and Location Method for Modular Multilevel Converter Based on the Voltage Variation Observations

A Novel Detection and Localization Approach of Open-Circuit Switch Fault for the Grid-Connected Modular Multilevel Converter.

A Submodule Fault Ride-Through Strategy for Modular Multilevel Converters with Nearest Level Modulation

IGBT Open-Circuit Fault Diagnosis for Modular Multilevel Converter With Reduced-Number of Voltage Sensor Measuring Technique

Fault Detection and Tolerant Control of Open-Circuit Failure in Mmc with Full-Bridge Sub-Modules

Open-circuit Faults Localization with error elimination for Modular Multilevel Converters under various control modes

An IGBT open-circuit fault detection method for modular multilevel converters

Energy-balancing Control Strategy for Modular Multilevel Converters under Submodule Fault Conditions

Detection and Localization of Submodule Open-Circuit Failures for Modular Multilevel Converters with Single Ring Theorem

A Threshold Adaptive Open-Circuit Submodule Fault Diagnosis Strategy for Modular Multilevel Converters

Fault-tolerant Design and Control of Modular Multilevel Converter-Based STATCOM