Abstract:This article proposes a fault-tolerant control method for an input-parallel–output-series (IPOS) converter under open-circuit switch failure, which mainly focuses on two parts: fault diagnosis (fault detection and fault identification) and remedial action. The fault diagnosis is realized based on immersion and invariant observer (I&IO), which has strong robustness to parameter uncertainty and external disturbances, and therefore, it can be designed using only the crude converter model with nominal parameters. Moreover, the sampling frequency required by the fault diagnosis is the same as the frequency required by the system controller. Thus, the fault diagnosis module can be easily embedded in the well-designed power system without extra sensors. Based on the method, the open-circuit fault in power switches can be detected and identified within two switching periods. As for remedial action, two redundant switches are needed for postfault reconfiguration. Also, the remedial action can be immediately triggered after the switch failure is detected. To reduce the complexity of remedial action, the same postfault reconfiguration will be carried out for the open-circuit failure in different switches. Besides, system controllers are also carefully designed to guarantee the performance of the postfault converter. Both simulations and experiments are conducted for the validations, and the results have shown the effectiveness, robustness, and rapidity of the proposed method.

Strong Tracking Filter Based Switching Converter Fault Diagnosis

Modeling and Parameter Identification of DC/DC Converters in Both CCM and DCM Mode

FAULT DIAGNOSIS FOR POWER ELECTRONIC CIRCUITS BASED ON HYBRID SYSTEM THEORYAND EVENT IDENTIFICATION

Online Fault Diagnosis Based on Strong Tracking Filter for Analog Circuit

Adaptive Control of DC-DC Converters Based on a Strong Tracking Filter

Dynamic State Estimation Enabled Health Indicator for Parametric Fault Detection in Switching Power Converters

Fault diagnosis scheme for open-circuit faults in switched reluctance motor drives using fast Fourier transform algorithm with bus current detection

Open-Circuit Switch Fault Diagnosis and Fault- Tolerant Control for Output-Series Interleaved Boost DC–DC Converter

Fault Diagnosis of Power Converter for Switched Reluctance Motor Based on Discrete Degree Analysis of Wavelet Packet Energy

Fault Diagnosis Based on Hybrid System Model and Filter for Power Electronic Circuits

A Novel Soft Fault Detection and Diagnosis Method for a DC/DC Buck Converter Based on Contrastive Learning

Fault Diagnosis Strategy of Four-Switch Buck-Boost Converter Based on Support Vector Machines

An Observer-Based Switch Open-Circuit Fault Diagnosis of DC-DC Converter for Fuel Cell Application

Detection and Identification of Power Switch Failures Using Discrete Fourier Transform for DC–DC Flying Capacitor Buck Converters

Predictive Control of Switching System for DC/AC Converter

Digital Twin Based Condition Monitoring for High Power Converters

Fault Detection and Identification Strategy Based on Luenberger Observer for Bidirectional Interleaved Switched—Capacitor DC–DC Converter Interfaced Microgrids

An Open-Switch Fault Diagnosis Method for Three-Phase Voltage Source Converter Using Tracking Differentiator

Reconstructed Phase Current-Based Fault Diagnosis Method for Interleaved Buck Converter

Stator Inter-Turn Fault Detection in Closed-Loop Controlled Drive Based on Switching Sideband Harmonics in CMV

Online fault diagnosis based on strong tracking filter for fossil-fired power unit