Abstract:Polyether-ether-ketone (PEEK) and polyimide (PI) are two kinds of engineering polymer materials widely used as roller bearing cages and rings under extreme environment because of their noise reduction and corrosion resistance properties. The Si3N4 ceramic is the most common ball bearing material. Many current engineering applications of ball bearings require aqueous lubrication. Therefore, this study presents the aqueous lubrication of tribopairs formed by PEEK and PI material sliding against Si3N4 ceramic. Experimental results show that two tribopairs exhibited the similar tribological properties under the dry condition. Water as a lubricant for the PI–Si3N4 tribopair pairs effectively reduces both friction coefficients by 35.5% and wear rates by 32%. The water absorption of PI induces better tribological properties by changing the tribopair surface properties. In addition, the dimples appearing on the PI tribopair surface under water generate additional hydrodynamic lubrication and further improve the friction properties of surface. The PEEK–Si3N4 tribopair shows similar friction coefficients under two kinds of environments. The wear rates under water are approximately more than two times of that under dry sliding. However, water inhibits the appearance of the crush phenomenon and enhances the carrying capacity of the tribopair. Energy dispersive spectroscopy and X-ray diffraction spectra demonstrate no chemical corrosion. The 3D profiler and SEM morphologies illustrate that the transfer film would be formed from the surface of PEEK under water but hindered under dry friction. Overall, the PI–Si3N4 tribopair exhibits better properties than PEEK under water and is promising for future applications in the bearing industry.

RESEARCH ON HYDRODYNAMIC PEEK JOURNAL BEARINGSLUBRICATED WITH WATER AND OIL

Lubrication Performance Analysis of Lead-Bismuth Internal-Feedback Bearings in the Nuclear Main Pump System

Analysis on dynamic experimental system of lubrication film properties of friction pairs in axial piston pump

Researches on Friction Performance of Water-Lubricated Polymer Composite Journal Bearings Based on Experiments

Experimental research on marine oil-lubricated stern tube bearing

Influence of Radial Load on PEEK Plastic Bearings Life Cycle under Water Lubricated Conditions

Ultralow friction of PEEK composites under seawater lubrication

Carbon Fibre Reinforced Bisphenol-a Type SPEEK Composite for Water Lubricated Superlubricity

Friction and wear performance of polyether ether ketone (PEEK) polymers in three lubrication regimes

A state-of-art review on the water-lubricated bearing

Tribological and Vibration Properties of Three Different Polymer Materials for Water-Lubricated Bearings

Investigations on Ways to Improve the Scuffing and Wear Behavior of Oil-Free Water-Based Lubricants for Gear Applications

Performance of a Direct Bonded Sub-Millimeter Peek Coating for Hydrodynamic Plain Bearings

Experimental Study on Material Properties of Bearing Bush of Water Lubricated Bearing

Experimental study on the feasibility of alternative materials for tilting pad thrust bearings operating in transition to mixed friction

Experimental Research of Abnormal Wear for Water-Lubricated Polymer Bearings under Low Speed, Heavy Pressure, and High Water Temperature

A study on improving friction and wear performance of bearing bush in radial piston hydraulic motor

Aqueous lubrication and surface microstructures of engineering polymer materials (PEEK and PI) when sliding against Si3N4

FRICTION PROCESSES OF SELECTED POLYMERS SLIDING ON STEEL AND DURALUMIN IN A LUBRICANT ENVIRONMENT

Tribological Behavior of Sulfonated Polyether Ether Ketone with Three Different Chemical Structures under Water Lubrication

Rheological Characterization and Tribological Evaluation of Water-Based Lubricants in AISI 52100 Bearing Steel