Experimental study on the feasibility of alternative materials for tilting pad thrust bearings operating in transition to mixed friction

Michał Wasilczuk,Michał Wodtke

DOI: https://doi.org/10.1007/s40544-023-0838-3

IF: 4.924

2024-02-04

Friction

Abstract:In hydrodynamic bearings traditional bearing alloys: Babbitts and bronzes are most frequently utilized. Polymer sliding layers are sometimes applied as a valuable alternative. Hard diamond-like carbon (DLC) coatings, which are also considered for certain applications may show some advantages, as well. Although material selection is of secondary importance in a full film lubrication regime it becomes important in mixed friction conditions, which is crucial for bearings with frequent starts and stops. Experimental research aimed at studying the performance of fluid film bearings in the specific operating regime, including the transition to mixed friction, is described in the paper. The tests were carried out on four tilting pad bearings of different material compositions: Steel/bronze, DLC/steel, steel/polyether ether ketone (PEEK), and steel/Babbitt. The tests comprised stopping under load and reproduction of the Stribeck curve by decreasing rotational speed to very low values, and observing the changes of friction force during the transition to mixed friction regime. Analysis of the transition conditions and other results showed clear differences between the tested bearings, illustrating the feasibility of less popular material compositions for bearings operating in specific conditions. More specifically, the DLC/steel bearing was demonstrating superior performance, i.e. lower friction, transition to mixed friction occurring at higher load, and more stable performance at start-stop regime over the other tested bearings.

engineering, mechanical

What problem does this paper attempt to address?

The problem that this paper attempts to solve is the performance of tilting - pad thrust bearings with different material combinations under mixed - friction conditions, especially the performance of these bearings under frequent start - stop conditions. Specifically, the research aims to evaluate the performance differences between traditional metal materials (such as steel/bronze, steel/white alloy) and modern alternative materials (such as steel/polyether - ether - ketone (PEEK), steel/diamond - like carbon (DLC) coatings) during the transition from fluid lubrication to mixed - friction. Through experimental research, the author hopes to reveal the feasibility of these different material combinations under specific operating conditions, especially their performance under mixed - friction conditions, which is particularly important for bearings that require frequent start - stop. The study found that the DLC/steel combination exhibited the best performance in all tests, with a lower friction coefficient, a higher load - carrying capacity, and more stable start - stop performance.