Abstract:Abstract Recent studies have benchmarked the prediction of wave vertical bending moment (VBM) of ship in waves [1][2], and found significant scatter among the numerical codes. Unfortunately, experimental data in extreme waves, that are relevant to ship design, are not often easily accessible, nor completely fitted to rigorous comparison to numerical codes. Then, the improvement of numerical tools and the modelling of ship’s internal loads still requires accurate experimental data measured in steep waves (ratio wave height H to wavelength λ, H/λ = 0.1) where the ship behavior and loads are modified by non-linearities. Thus, in order to validate simulation codes, which underlies rules requirement, and to establish criteria that makes ships safer to sail in severe sea conditions, experiments are carried out in the 50m × 30m × 5m hydrodynamic and ocean engineering tank of Ecole Centrale Nantes. A 1/65th scaled model of a 6750-TEU containership is used. The ship is moored and several combinations of wavelength and wave height are tested. While segmented hulls are commonly instrumented with strain gauges, the present experiments are performed on a segmented hull with a 6DOF sensor located close to the amidship. This setting allows for a very stiff model which dramatically reduces the hydroelastic effects. According to previous study [1], the position of the sensor is chosen where the bending moment is supposed to reach a maximum value. The model motion is measured through a Qualisys IR tracking system and accelerometers are located on the fore and aft of the beam. Also, each of the 9 segments is equipped with a 3DOF dynamometer to measure the hydrodynamic loads on the hull. This allows for recovering the hydrodynamic loads on the segments and then to compute the shear force and bending moment discretized all over the ship length. A comparison is therefore possible with the 6DOF sensor. Details of the computations are given in the paper. A particular attention is paid to the reproducibility and repeatability of the tests. The innovative experimental setup and the measured data are presented in the paper. Based on previous studies [3], the effects of the non-linearities are also discussed.

DEVELOPMENT, TEST AND SELECTION OF A SHOCK MITIGATION SEAT FOR AN ALLWEATHER LIFEBOAT

Effectiveness of suspension seats in maintaining performance following military high-speed boat transits

Performance of an Elastic Polymer Foam Cushion in Attenuating Responses of Shipboard Standing-Men to Ship Vertical Shock

A Novel Efficient Method to Evaluate the Dynamic Response of Laminated Plates Subjected to Underwater Shock

Shock Absorbers Damping Characteristics by Lightweight Drop Hammer Test for Naval Machines

Research on Reliability Growth of Shock Absorption System in Rapid Secure Device of Shipboard Helicopter

Experimental Investigation on the Dynamic Response of Scaled Ship Model with Rubber Sandwich Coatings Subjected to Underwater Explosion

Experimental Assessment of Vertical Shear Force and Bending Moment in Severe Sea Conditions

Tests and evaluation for personnel anti-shock tiles based on dummy shock response

A New Type of Rubber Sandwich Coated Onto Ship for the Use of Underwater Explosion Shock Mitigating

Simulation and experiment of the magnetorheological seat suspension with a seated occupant in both shock and vibration occasions

Design and experimental study of lightweight fireproof bidirectional bead bulkheads in a cruise ship

Development and Flight Demonstration of an Active Seat Mount System for Aircrew Whole-Body Vibration Mitigation on NRC Bell-412 Helicopter

Vibration Response Analysis of a New Scientific Research Ship Based on Finite Element Modeling

Analysis and Test of Shock Response of an Anti-impact Chair

Evaluation of the vibration transmitted to pilot’s body parts to determine the contribution of different design parameters in deficiency of available seats

Application of Sandwich Panel in Anti-shock Design of Warship's Side Structure

Dynamic response and shock resistance of layered claddings subjected to a non-contact underwater explosion

Numerical and experimental studies on hydrodynamic performance of a small-waterplane-area-twin-hull (SWATH) vehicle with inclined struts

Coupled occupant-suspension-seat system analysis and vehicle-specific design optimization

Investigation of vessel slamming and fatigue using a full-scale test sequence