Abstract:Diamond-Like Carbon (DLC) is thought to be a potential material in solving heat dissipation problems in light emitting diode module packages. It is of vital importance in evaluating the thermal conductivity of DLC film deposited on a silicon substrate. In this paper, the molecular dynamics method is used to simulate the formation of a DLC film by the deposition of carbon atoms on a isilicon substrate. Tersoff potential is adopted to reproduce the structures and densities of silicon, carbon, and SiC. A silicon substrate consisting of 544 atoms is located at the bottom of the simulation domain. The substrate is kept at a temperature of 600 K through a Noose-Hover thermostat. Carbon atoms are injected into the substrate individually every 0.5 ps at an energy of 1 eV. After a 7.5 ns deposition process, a 4 nm amorphous film containing 15000 carbon atoms is formed. Injected carbon atoms and substrate silicon atoms are intermixed at the bottom layer of the deposited film while the rest of the film contains only carbon atoms. The density of the film decreases slightly with the increase of the height of the deposited film and the average density is 2.8 g/cm3. Analysis of the coordination number shows that the sp3 fraction of carbon atoms in the film also decreases with the increase of the height of the deposited film, with a maximum value of 22%. It might be caused by the continuous impacts of the subsequently injected carbon atoms on the previously formed DLC film. The thermal conductivities of the DLC film in the planar and normal directions are calculated by the Green-Kubo method. The thermal conductivity of pure diamond film is also calculated for comparison. The results show that the planar thermal conductivity of the deposited DLC film is approximately half of that of the pure diamond film with the same size. It is higher than the normal thermal conductivity of the deposited film. The thermal conductivities of the DLC film in both planar and normal directions increase with the increase of film density and sp3 fraction in the DLC film. The results indicate that the local tetrahedral structure of sp3 carbon atoms contributes to the improvement of thermal conductivity in the DLC film.

Effect of the thickness on electrical resistance of thin diamond-like carbon coatings on silicon substrate

Electronic-Properties of Semiconducting Diamond-Like Carbon Diamond

Effect of Thickness on Structures of Ultrathin Diamond-Like Carbon Films

Dep Osition and Thermal Conductivity of Diamond-Like Carb on Film on a Silicon Substrate

Electrochemical Characterization of Diamond Like Carbon Thin Films

Optical Quantum-Size Effects in Diamond-Like Carbon Superlattice Structures

Optical Study of Low Energy Ion-Beam-Assisted Deposited Diamond-Like Carbon Films

Evaluation of Diamond-Like Carbon Films Electrodeposited on an Al Substrate from the Liquid Phase with Pulse-Modulated Power

Mechanical properties of diamond like carbon coatings prepared by microwave electron cyclotron resonance plasma chemical vapour deposition process

Effects of sp3 bond ratio and modulation ratios on nanotribology behaviors of diamond-like carbon coatings investigated using atomistic nanoscratching simulations

The role of substrate bias and nitrogen doping on the structural evolution and local elastic modulus of diamond-like carbon films

Study of Mechanical Properties of Diamond-Like Carbon Coatings for Bio-Medical Applications

Structure and mechanical properties of diamondlike carbon films produced by hollow-cathode plasma deposition

Multilayer Diamond‐Like Carbon Films on Monocrystalline Diamond

Blood compatibility and sp3/sp2 contents of diamond-like carbon (DLC) synthesized by plasma immersion ion implantation-deposition

Tribological Performance of Ultrathin Diamond-Like Carbon Films Prepared by Plasma-Based Ion Implantation

Structures and tribological properties of diamond-like carbon films prepared by plasma-based ion implantation on Si

Thermal Conductive Performance of Deposited Amorphous Carbonmaterials by Molecular Dynamics Simulation

Micromechanical properties of hydrogenated diamond-like carbon multilayers

Mechanical and Tribological Properties of Diamond-Like Carbon Films Deposited by Electron Cyclotron Resonance Microwave Plasma Chemical Vapor Deposition

Synthesized by Plasma Immersion Ion Implantation-Deposition