Abstract:In order to adapt hydrotalcite based sorbents (LDO) to high temperature CO2 sorption and suitable temperature for tar steam reforming, the addition of CaO was investigated, maintaining their structure to keep porosity and accessibility but mostly assure the CO2 sorption stability during sorption/desorption cycles. In co-precipitation synthesis, various interlayer anions with different sizes and valences (carbonate, oxalate, and stearate) and various pH values were studied for different Mg/Ca ratios. The characterization of these sorbents (LDO) by TGA, XRD, N2 adsorption, SEM, sorption capacity, and sorption/desorption stability (cyclic TGA) permitted to understand the effect of the various synthesis conditions and to highlight the interest of oxalate use as interlayer anion. Typical LDH sand roses were formed with carbonate and oxalate anions after calcination until Mg/Ca/Al ratio = 1/2/1. For carbonate, this optimal ratio reached the highest sorption capacity and CaO sites accessibility at 600°C, better than pure CaO. However, the best stability during cycles was obtained with the sorbent from oxalate and Mg/Ca/Al ratio = 1.5/1.5/1 at pH 10 for which sorption results were almost the best values observed. For these two samples, the observed macroporosity were associated to the highest specific surface area and pore volume.Statement of NoveltyIn hydrotalcite structure, a width interlayer space permits to integrate various anions (CO32-, SO4-2, or NO3-) in order to modify CO2 sorption kinetics and capacity. The spheroidal “sand rose” morphology observed with CO32- anions explained the large BET surface area and the better CO2 sorption capacity. Stearate (and longer molecules) exchange was extensively studied as long-carbon-chain organic anion and allowed a better CO2 capture performance.This work focuses on another interlayer anion (oxalate) with the same valence of carbonate (2), a shape and valence different to stearate (1), and not yet reported in the literature. The novelty is to demonstrate that oxalate can replace carbonate as interlayer anion and moreover stearate by a less toxic one.

Layered double hydroxides for CO2 adsorption at moderate temperatures: Synthesis and amelioration strategies

Basic Properties of MgAl-Mixed Oxides in CO2 Adsorption at High Temperature

Progress on Photocatalytic Elimination of CO2 and Gaseous Pollutants over LDHs-based Materials

Ca-Based Layered Double Hydroxides for Environmentally Sustainable Carbon Capture

Modified Layered Double Hydroxides for Efficient and Reversible Carbon Dioxide Capture from Air

Recent advances in CO2 capture and mineralization using layered double hydroxide-based materials: A review

Aqueous miscible organic-layered double hydroxides with improved CO 2 adsorption capacity

Synthesis of Elevated Temperature CO2 Adsorbents from Aqueous Miscible Organic-Layered Double Hydroxides

Development of carboxyl-layered double hydrotalcites of enhanced CO 2 capture capacity by K 2 CO 3 promotion

Dynamic Intermediate-Temperature CO2 Adsorption Performance of K2CO3-Promoted Layered Double Hydroxide-Derived Adsorbents

Evaluation of the Behavior of Hydrotalcite Like-Materials for CO2 Capture

Enhancing Adsorbent Performance for Direct Air Capture of CO2 by In-Situ Amine-Grafting of Layered Double Hydroxides

Structural engineering of NiFe-Layered double hydroxides and halloysite composites for efficient CO 2 capture

Scalable Synthesis of Amine-Grafted Ultrafine Layered Double Hydroxide Nanosheets with Improved Carbon Dioxide Capture Capacity from Air

Layered Double Hydroxide Nanoparticles/Microparticles (Mg/Al = 2) as Adsorbents for Temperature Swing Adsorption: Effect of Particle Size on CO 2 Gas Evolution Behavior

Mesoporous alumina-supported layered double hydroxides for efficient CO2 capture

Comprehensive Analysis of the Chemical and Structural Transformations of Mg–Al–CO3 Layered Double Hydroxides with Different Mg/Al Ratios at Elevated Temperatures

Development of a high temperature CO2 sorbent based on hydrotalcite for a H2-rich syngas production from biomass.

Synthesis, characterization and high temperature CO2 capture capacity of nanoscale Ca-based layered double hydroxides via reverse microemulsion

Layered Double Oxide/activated Carbon-Based Composite Adsorbent for Elevated Temperature H 2 /CO 2 Separation

Sorption-enhanced Water Gas Shift Reaction by in Situ CO2 Capture on an Alkali Metal Salt-Promoted MgO-CaCO3 Sorbent