Abstract:Oil-loaded polymer composites have become a research focus in tribology due to the good environmental stability and excellent performance. Usually, it is necessary to endow the polymer with a porous structure to facilitate lubricating oil storage. However, most methods require complex operating steps, making it difficult to control the complex shape of materials, and excessive pores often lead to an imbalance between the oil storage and retention rates. At the same time, the mechanical properties of the material can also be negatively affected. Developing a simple synthesis method to obtain oil-loaded polymer composite materials with good self-lubricating and mechanical properties still faces challenges. Herein, a one-pot synthesis method for oil-loaded self-lubricating polymers was proposed, which embeds the porous silica nanoparticles loaded with lubricating oil into the polymer and uses vat photopolymerization-based technologies to construct the polymer with various complex and delicate structures. After a series of treatments, such as photocuring and cleaning, an oil-loaded polymer-based composite material with good self-lubricating performance was prepared. Benefiting from the rich mesoporous pore structure of mesoporous silica, high specific surface area of 467 m 2 g -1 , and pore volume of 1.06 cm 3 g -1 , the oil content and retention rate of the composite materials are at a high level. In addition, by combining oil-loaded mesoporous silica nanoparticles with 3D printing, controllable preparation of complex shapes of self-lubricating composite materials has been achieved. During the friction performance testing process, the oil-loaded particles in the polymer composite can continuously provide lubricating oil on the friction surface, thus making the friction coefficient and wear rate reduced by 85.7% and 97.7%.

Frictional Behaviors of 3D-Printed Polylactic Acid Components With Spiral-Groove Surface Textures Under Oil Lubrication

Multiobjective optimization of tribological characteristics of 3D printed texture surfaces for ABS and PLA Polymers

Study on friction properties of different abrasive materials and polylactic acid materials

Tribological Characterisation and Modelling for the Fused Deposition Modelling of Polymeric Structures under Lubrication Conditions

Investigation of tribological properties of industrial products with different patterns produced by 3D printing using polylactic acid

Tribological Performance and Enhancing Mechanism of 3D Printed PEEK Coated with In Situ ZIF-8 Nanomaterial

Investigation of Tribological Properties of PI/FEP Laminated Composites Under Dry Sliding, Water- and Oil-Lubricated Conditions

Synergistic Effect of Carbon Micro/Nano-Fillers and Surface Patterning on the Superlubric Performance of 3D-Printed Structures

Optimization of 3D Printing Parameters for Enhanced Surface Quality and Wear Resistance

Tribological behavior of 3D printed biomimetic surfaces

Tribological Behaviour of Fused Deposition Modelling Printed Short Carbon Fibre Reinforced Nylon Composites with Surface Textures under Dry and Water Lubricated Conditions

Mechanical and Wear Characteristics Investigation on 3D Printed Silicon Filled Poly (Lactic Acid) Biopolymer Composite Fabricated by Fused Deposition Modeling

Tribological behavior of 3D printed nanofluid reinforced photosensitive self-lubricating polymer materials

3D Printing Composite with Microcapsules for On-Demand Lubrication

3D printing of PTFE-filled polyimide for programmable lubricating in the region where lubrication is needed

Tribological Performance of Additively Manufactured AISI H13 Steel in Different Surface Conditions

Experimental Investigation on Friction Behavior of Selective Laser Sintering Processed Parts

Effects of Laser Surface Texturing and Lubrication on the Vibrational and Tribological Performance of Sliding Contact

Tribological Performance of Additive Manufactured PLA-Based Parts

Evaluation of the Influence of Technological Parameters of Selected 3D Printing Technologies on Tribological Properties

Impact of processing defects on microstructure, surface quality, and tribological performance in 3D printed polymers