Abstract:The method of construction and attestation of a numerical model of cold stamping of thin-walled products made of anisotropic metal sheet for the design of technological operations is proposed. The relations of the associated law of plastic flow with the Barlat flow function and isotropic strain hardening are used. The method of design and processing the experiment is proposed for their identification. The forming limit curve is approximated numerically by the Marciniak - Kuczynўski method, and for its identification it is proposed to use a failure test under uniaxial tension and press equipment as an experimental. To do this, a coordinate grid is applied to a flat blank by laser engraving, whose distortions near the zones of strain localization and failure of the vessel give additional points of the forming limit curve. The constants of the Peng - Landel potential are found to describe the elasticity of a polyurethane die under large deformations using tests for free and constrained compression. All tests according to the method were performed for low-carbon sheet steel DC04EK 0.7 mm and SKU-PFL polyurethane. A numerical model of the process in the LS-DYNA package is designed using material models from its library. The calculations according to the model were confirmed by experiment, for which the main deformations were determined by the distorted coordinate grid on the workpiece after each operation at the control points. The calculation of the sequence of stages of stamping, drawing and bulging of the workpiece in the production of the vessel with and without intermediate annealing is performed and the dangerous zones and mechanisms of their formation are determined.

Theoretical studies of reverse extrusion of steel pipe by conical punch

RADIAL EXTRUSION OF A PIPE BILLET WITH INTERNAL LEDGE. EXPERIMENTAL VERIFICATION OF THEORETICAL FORMULAS DURING EXTRUSION WITH HARDENING OF STEELS 10, 12KH18N9T AND BRASS L63

RADIAL EXTRUSION OF A PIPE BILLET WITH INTERNAL LEDGE. METHODS FOR CALCULATING THE TECHNOLOGICAL PARAMETERS OF EXTRUSION OF PRODUCTS WITH THE SAME RADII OF THE UPPER AND LOWER PARTS

THEORETICAL COMPUTATION ON THE EXTRUSION OF LARGE SCALE STEEL PIPE BASED ON UPPER BOUND METHOD

RADIAL EXTRUSION OF A PIPE BILLET WITH INTERNAL LEDGE. ACTUALITY AND STATEMENT OF PROBLEM

Bending of sheets and profiles on a four-roll machine for rocket bodies, pipe and frame products. Part 13

Study of Chromium Steel Ductility During Pipe Extrusion

Investigation of hot combined extrusion of steel hollow conical parts

Additional Forming of a Pipe Billet in the Production of Thick-Walled Large Diameter Pipes

A Theoretical Study of the Expansion Metal Tubes

Technology Optimization Analysis of Three-Roll Rotary Piercing Process for Seamless Steel Pipe

Optimization of the Processes of Forming and Welding of Large-Diameter Pipes with the Help of Mathematic Simulation

Theoretical and Experimental Study on the Effect of Selected Parameters in a New Method of Extrusion with a Movable Sleeve

A Theoretical Model of the Inversion Tube over a Conical Die

A Theoretical Model of the Shrinking Metal Tubes

3-D rigid plastic FEM simulation of extruding-bulging process of tee tubes

Numerical and experimental analysis of the isothermal high temperature pneumoforming process

RADIAL EXTRUSION OF A PIPE BILLET WITH INTERNAL LEDGE. DETERMINATION OF KINEMATIC AND STRESS STATES

FE Modeling of Warm Flanging Process of Large T-pipe from Thick-Wall Cylinder

SIMULATION OF MULTI-STAGE COLD FORMING OF A THIN-WALLED VESSEL

Analysis of Sheet Metal Extrusion Process Using Finite Element Method