Abstract:Some biological surfaces were proved to have excellent anti-wear performance. Being inspired, Nd:YAG pulsed laser was used to create striated biomimetic laser hardening tracks on medium carbon steel samples. Dry sliding wear tests biomimetic samples were performed to investigate specific influence of distribution of laser hardening tracks on sliding wear resistance of biomimetic samples. After comparing wear weight loss of biomimetic samples, quenched sample and untreated sample, it can be suggested that the sample covered with dense laser tracks (3.5 mm spacing) has lower wear weight loss than the one covered with sparse laser tracks (4.5 mm spacing); samples distributed with only dense laser tracks or sparse laser tracks (even distribution) were proved to have better wear resistance than samples distributed with both dense and sparse tracks (uneven distribution). Wear mechanisms indicate that laser track and exposed substrate of biomimetic sample can be regarded as hard zone and soft zone respectively. Inconsecutive striated hard regions, on the one hand, can disperse load into small branches, on the other hand, will hinder sliding abrasives during wear. Soft regions with small range are beneficial in consuming mechanical energy and storing lubricative oxides, however, soft zone with large width (>0.5 mm) will be harmful to abrasion resistance of biomimetic sample because damages and material loss are more obvious on surface of soft phase. As for the reason why samples with even distributed bionic laser tracks have better wear resistance, it can be explained by the fact that even distributed laser hardening tracks can inhibit severe worn of local regions, thus sliding process can be more stable and wear extent can be alleviated as well. (C) 2017 Elsevier Ltd. All rights reserved.

Hardness Difference Effect of Biomimetic Surface with Hard-Soft Structure on Oil - Lubrication Wear Resistance

Bio-inspired Wearable Characteristic Surface: Wear Behavior of Cast Iron with Biomimetic Units Processed by Laser

Effect of Dual Hardness Combinations on Wear Resistance of Laser Prepared Bionic Grey Iron Surfaces.Effect of Dual Hardness Combinations on Wear Resistance of Laser Prepared Bionic Grey Iron Surfaces

Lubricating Property of Cast Iron Combined with Two-Scale Unit Structure by Biomimetic Laser Treatment

Wear Behavior of Quenched Iron with Various Shapes and Unit Processed Through Two-Step Laser Alloying of C Powder

Effect of the Microhardness Difference Between Base Metal and Bionic Coupling Unit on Wear Resistance of Gray Cast Iron

Effect of Distribution of Striated Laser Hardening Tracks on Dry Sliding Wear Resistance of Biomimetic Surface

Hard-soft Biomimetic Structure Distribution Enhanced Wear Resistance of AISI1045 Steel by Laser Processing

Effect of different hardness units on fatigue wear resistence of low hardenability steel

Hardness Effect on Three-Body Abrasive Wear Under Fluid Film Lubrication

Effect of hardness gradient of laser bionic coupling unit on wear resistance of 6082 aluminum alloy

Tribological behaviour and wear mechanism of ADI with different hardness values

Effect of Interaction Between Cementite and Pearlite on Two-Body Abrasive Wear Behaviors in White Cast Iron

Effect of Medium on Friction and Wear Properties of Compacted Graphite Cast Iron Processed by Biomimetic Coupling Laser Remelting Process

Wearability of Non-Smooth Surface with Laser Treatment in the Different Cooling Media

Interface Adhesion During Sliding Wear in Cast Iron after Hot Deformation

Study on laser prepared reinforcement unit distribution of large scale non-uniform hardness surface of gray cast iron against wear

Influence of Varying Forms of Bionic Units on Repairing Remaining Quenching Surface of Gray Cast Iron

Influence of H13 steel unit on wear behavior of vermicular cast iron

Wear properties of H13 with micron scale and nano scale grains bionic units processed by laser remelting

Contrast Role of Third Body Layer and Hard Abrasives in the Wear Process of a TiAlSiN Hardness-Modulated Multilayer Coating: A Case Study on the Effect of Normal Load and Velocity