Abstract:This study proposes a research approach to reduce wall stress by optimizing the drill rod structure. Through theoretical analysis, numerical simulation, and industrial tests, a stress model for the drill rod inside the hole was established, and a wall stress equation was derived. The effects of various parameters on wall stress were analyzed. The study suggests optimizing the drill rod structure to reduce the disturbance‐induced wall stress. Gas extraction drilling is a necessary measure for managing gas hazards. For soft coal seams where gas extraction drilling holes are prone to collapse, it is believed that drill rod disturbance is the main cause of hole collapse. This study proposes a research approach to reduce wall stress by optimizing the drill rod structure. Through theoretical analysis, numerical simulation, and industrial tests, a stress model for the drill rod inside the hole was established, and a wall stress equation was derived. The effects of various parameters on wall stress were analyzed. The study suggests optimizing the drill rod structure to reduce the disturbance‐induced wall stress. SolidWorks was used for drilling stress simulation, and a four‐winged concave groove drill rod was developed. After strength verification, comparative industrial tests were conducted. The research results show that as the line density increases, the wall stress of the drilling hole increases. As the length of the suspended section increases, the wall stress initially decreases and then increases. With increasing drilling thrust, wall stress increases linearly, and the growth rate is greater with a larger diameter difference between the drill hole and the drill rod. Numerical simulation results indicate that the critical point maximum stress at the hole entrance, the critical point maximum stress at the hole bottom, and the average stress at the bottom section of the four‐winged concave groove drill rod with a concavity of 5 are significantly reduced compared to those of circular and grooved drill rods. Industrial test results show that using the four‐winged concave groove drill rod significantly reduces the extent of hole collapse. This study provides a reference for addressing the issue of hole collapse in gas extraction drilling for soft coal seams.

Numerical Analysis of the Stress Distribution and Concentration Factors of the Tool Joint of the Directional Drill Pipe

Numerical modeling and the ultimate bending experiment of the directional drill pipes bending at the dog-leg of the multi-branch well

Failure Analysis of Drill Pipe during Working Process in a Deep Well: A Case Study

Drill pipe joints fatigue analysis and optimization under special working conditions

A Model to Compute the Mechanical Property of Drillpipe Tool Joint and Its Application

Experimental Study on Measuring the Stress of Coal Based on the Speed of Drilling Rod and the Amount of Drilling Chip

A new method for monitoring coal stress while drilling process: theoretical and experimental study

3D finite element analysis and optimization of welding residual stress in the girth joints of X80 steel pipeline

Theoretical analysis of drilling cuttings considering stress zoning of surrounding rock and its application in stress detection

Theoretical and experimental studies on relationship between working parameters of cone drill and rock strengths

Mechanism and application of drill pipe bending induced borehole collapse in soft coal seam drilling

Nonlinear Analysis of the Threaded Connection with Three-Dimensional Finite Element Model

Field and Numerical Study on Deformation and Failure Characteristics of Deep High-Stress Main Roadway in Dongpang Coal Mine

Rapid In-Situ Stress Measurement in Vertical Borehole Based on Borehole Diametrical Deformation Analysis

A new method for characterization of stress concentration degree of coal mine roadway surrounding rock

Finite Element Analysis of Modeling Residual Stress Distribution in All-position Duplex Stainless Steel Welded Pipe

Numerical Simulation and Experimental Confirmation of a Bimetallic Pipe Forming Process

Study on hot spot stress distribution of three-planar tubular Y-joints subjected to in-plane bending moment

Research on the Effective Means of Improving the Screw Strength of Drill Pipe Joint

Surrounding rock stress distribution characterization via unit cutting energy

Numerical Investigation of Influences of Drilling Arrangements on the Mechanical Behavior and Energy Evolution of Coal Models