Abstract:Rock burst disasters severely restrict the safe and efficient mining of coal. The fundamental cause of their occurrence is the concentration of stress within the coal mass. Stress monitoring in coal seam drilling is widely used as an effective method for rock burst monitoring. However, how to scientifically and reasonably set the critical values of early warning indicators that match the conditions of each mine has always been a key issue restricting the accurate prediction of rock burst by the drilling stress method. This paper adopts a method combining theoretical analysis and field practice to conduct research on the critical values of drilling stress early warning indicators. Based on perturbation response instability theory, a mechanical model for the occurrence of impact ground pressure has been established. Based on the instability theory of disturbance response, a mechanical model for the occurrence of impact ground pressure has been established, leading to the derivation of the expression for the near-field critical stress of impact ground pressure events. The theoretical formula for the critical value of drilling stress early warning indicators was obtained based on the difference between the critical stress of rock burst occurrence and the actual stress in the roadway. This formula includes the mechanical parameters of the coal mass and its propensity for rock burst, roadway support stress, mining depth, stress concentration coefficient, and the initial installation pressure of the stress gauge. They can be determined by the geological and mining technical conditions of each mine. This theoretical formula breaks the uniformity of the critical values for stress warning indicators in various mine drill holes, allowing each mine to scientifically determine its critical value based on its own conditions. This theoretical method has been applied to a high-stress mine in Shanxi, China, and the critical values of drilling stress early warning indicators were obtained. When the monitored stress exceeded the critical value, dynamic phenomena of anchor rod and cable fractures occurred in the roadway roof. The distribution of microseismic events also shifted towards the warning area, and the microseismic monitoring indicators reached the warning values. This confirmed the engineering feasibility of the critical values for drilling stress early warning indicators determined by the theoretical method.

Surrounding rock stress distribution characterization via unit cutting energy

Study Of Surrounding Rock Damage Induced By Tunnel Boring Machine Driving Tunnel At West Route Of South To North Water Transfer Project

A new method for characterization of stress concentration degree of coal mine roadway surrounding rock

A new method for monitoring coal stress while drilling process: theoretical and experimental study

Theoretical analysis of drilling cuttings considering stress zoning of surrounding rock and its application in stress detection

Theoretical Study of Surrounding Rock Loose Zone Scope Based on Stress Transfer and Work–Energy Relationship Theory

Theoretical study on the critical index of rock burst stress monitoring in coal seam drilling

A method for assessing the risk of rockburst based on coal-rock mechanical properties and In-Situ ground stress

Relationship model for the drilling parameters from a digital drilling rig versus the rock mechanical parameters and its application

Experimental Study on Measuring the Stress of Coal Based on the Speed of Drilling Rod and the Amount of Drilling Chip

Determination of cutting force and failure surface using a blunt cutter under confining condition: analytical modelling

Study on a digital drilling test–based rock uniaxial compressive strength measurement method

Research on rockburst proneness evaluation based on interpretation of drilling parameters

Rock Strength Determination Based on Rock Drillability Index and Drilling Specific Energy: Numerical Simulation Using Discrete Element Method

Prediction model for disc cutter wear during hard rock breaking based on plastic removal abrasiveness mechanism

Research on discrete element modeling and numerical simulation of cutting rock behavior under impact load

Real-time rock strength determination based on rock drillability index and drilling specific energy: an experimental study

The response mechanism and testing method of the rock elastic modulus while drilling

Study of contact pressure distribution between cutter and rock surface using the discrete element method

Strength prediction and drillability identification for rock based on measurement while drilling parameters

Estimation of mechanics parameters of rock in consideration of confining pressure using monitoring while drilling data