Abstract:The discrete element models of rock cutting were established, and the reliability of the model was verified in comparison with the scratch test results and finite element simulation results. This study simulated the process of rock cutting under an impact load, and the influences of the static and impact loads on the cutting force and rock breaking were analyzed. A methodology is presented to increase drilling efficiency by selecting the suitable impact properties according to different drilling parameters.Combining well‐drilling hammers with polycrystalline diamond compact bits to break rock under cutting load and impact load is an effective way to improve drilling efficiency. Although impact load can enhance the cutting efficiency of the cutter, excessive impact can also cause the cutter to be subjected to additional vibrations, which can decrease its working life. Knowledge of laws governing the changes in the cutting force of the cutter under impact load is essential for the design and selection of well‐drilling hammers. Based on rock scratch tests and finite element rock cutting model, a discrete element modeling (DEM) rock cutting model was established to analyze the rock breaking and cutting force. Then, the material parameters of rock samples were determined, and the simulation parameters were corrected. Finally, a DEM rock cutting model under an impact load was established. The results showed that when there was an obvious difference between the average cutting force and mean peak cutting force, which corresponded to the rock‐breaking transition from ductile to brittle, with introduction of the impact load leading to an earlier transition. The cutting force variance was proportional to the impact amplitude, and the increase in the cutting force variance became more obvious when the static load exceeded the critical transition weight. When the ratio of the impact amplitude to the static load was greater than 50%, the mean and variance of the cutting force increased rapidly. Under the same impact amplitude, the impact frequency had little effect on the average cutting force, but a higher frequency could significantly reduce the variance of the cutting force under a high static load (i.e., it could alleviate the fluctuation of the cutting force). These results provide a reference for the selection of well‐drilling hammers and optimization of the impact load.

Study of contact pressure distribution between cutter and rock surface using the discrete element method

Development of a Real-Time Monitoring and Calculation Method for TBM Disc-Cutter's Cutting Force in Complex Ground

The energy method to predict disc cutter wear extent for hard rock TBMs

Fragmentation Energy-Saving Theory of Full Face Rock Tunnel Boring Machine Disc Cutters

Research on Numerical Simulation of Rock Breaking Using Tbm Disc Cutters Based on Udec Method

Study of Rock-Cutting Process by Disc Cutters in Mixed Ground based on Three-dimensional Particle Flow Model

Comparative Study of the Rock-breaking Mechanism of a Disc Cutter and Wedge Tooth Cutter by Discrete Element Modelling

Experimental and Numerical Investigations on Rock Breaking of TBM Disc Cutter Based on a Novel Platform with Rotational Cutting

Interaction between partial-worn TBM cutters and rocks: experimental and numerical investigation

Comparison of DEM Models with Different Elemental Dimensions for TBM Disc Cutter Rock Fragmentation

Analysis on the Rock–Cutter Interaction Mechanism During the TBM Tunneling Process

Penetration behaviour of TBM disc cutter assisted by vertical precutting free surfaces at various depths and confining pressures

Full-scale Test of Disc Cutter Rotary Cutting in TBM Tunnelling: a Case Study of Mawan Granite in Shenzhen, China

An experimental and numerical investigation on rock cutting behavior of specially-shaped PDC cutter

Experimental and numerical investigations on the force characteristics of cutter in different regions of the TBM cutterhead

Study of the cutter-rock interaction mechanism during TBM tunnelling in mudstone: insight from DEM simulations of rotatory cutting tests

Discrete Element Modeling of the Effects of Cutting Parameters and Rock Properties on Rock Fragmentation

Prediction model for disc cutter wear during hard rock breaking based on plastic removal abrasiveness mechanism

Investigation on rock breaking and optimum spacing of TBM cutters under confining stress using a continuum-discontinuum method

Investigating the cutting force of disc cutter in multi-cutter rotary cutting of sandstone: Simulations and experiments

Research on discrete element modeling and numerical simulation of cutting rock behavior under impact load