Abstract:We present designs that enable a significant increase of solar absorption in ultra-thin (100–300 nm) layers of gallium arsenide. In the wavelength range from 400–860 nm, 90–99.5% solar absorption is demonstrated depending on the photonic crystal architecture used and the nature of the packaging. It is shown that using only two hundred nanometer equivalent bulk thickness of gallium arsenide, forming a slanted conical-pore photonic crystal (lattice constant 550 nm, pore diameter 600 nm, and pore depth 290 nm) packaged with SiO2 and deposited on a silver back-reflector, one can obtain a maximum achievable photocurrent density (MAPD) of 26.3 mA cm−2 from impinging sunlight. This corresponds to 90% absorption of all available sunlight in the wavelength range 400–860 nm. Our optimized photonic crystal design suggests that increasing the equivalent bulk thickness of GaAs beyond 200 nm leads to almost no improvement in solar absorption, while reducing it to 100 nm causes less than 10% reduction in MAPD. Light-trapping in the 200 nm conical pore photonic crystal provides solar absorption exceeding the Lambertian limit over the range of 740–840 nm. The angular dependence of the MAPD for both S- and P-polarizations is also investigated and shows no substantial degradation in the range 0–30°. More dramatic light-trapping and solar absorption is demonstrated in photonic crystals consisting of conical nanowires. Using 200 nm equivalent bulk thickness of GaAs (lattice constant 500 nm, cone base diameter 200 nm, and cone height 4.77 μm) packaged in SiO2 and deposited on a silver back-reflector, an MAPD of nearly 27 mA cm−2 is found. This corresponds to absorption of 96% of all available sunlight in the wavelength range 400–860 nm. A clear separation of the solar spectrum along the length of each nanowire is also evident. In the absence of SiO2 packaging, this MAPD increases to 28.8 mA cm−2, in excess of the corresponding Lambertian limit of 28.2 mA cm−2. Most remarkably we find that, if the equivalent bulk thickness of GaAs is increased to 300 nm, nearly 100% of relevant sunlight is absorbed by the conical nanowire photonic crystal.

Absorption enhancement using photonic crystals for silicon thin film solar cells

Absorbing photonic crystals for silicon thin-film solar cells: Design, fabrication and experimental investigation

Progress in thin-film silicon solar cells based on photonic-crystal structures

High-efficiency photonic crystal solar cell architecture

Thin-film silicon solar cells: photonic design, process and fundamentals

Improving thin-film crystalline silicon solar cell efficiencies with photonic crystals

Electro-Optical Simulation Of In Ultra-Thin Photonic Crystal Amorphous Silicon Solar Cells

Nano-Photonic Structures for Light Trapping in Ultra-Thin Crystalline Silicon Solar Cells

Synergistic plasmonic and photonic crystal light-trapping: Architectures for optical up-conversion in thin-film solar cells

Photonic Crystal Structures for Light Trapping in Thin-Film Si Solar Cells: Modeling, Process and Optimizations

Designing High-Efficiency Thin Silicon Solar Cells Using Parabolic-Pore Photonic Crystals

Light trapping regimes in thin-film silicon solar cells with a photonic pattern

Near perfect solar absorption in ultra-thin-film GaAs photonic crystals

Experimental Demonstration of Quasi-Resonant Absorption in Silicon Thin Films for Enhanced Solar Light Trapping

Nanoimprint Photonic Crystal Film Enhanced Light-Trapping in a-Si Thin Film Solar Cells

Thin Film Silicon Solar Cell Design Based On Photonic Crystal And Diffractive Grating Structures

Light Absorption Enhancement of Amorphous Silicon Film Coupled with Metal Nanoshells

Enhanced Light Absorption in Thin Crystalline Silicon Solar Cells with Silica Nanoparticles

Effects of One-Dimensional Photonic Crystal on Thin Film Silicon Solar Cells

Enhanced Omnidirectional Optical Absorption in a Nanopatterned Silicon Thin Film for Photovoltaic Applications