Abstract:The presence of methylene blue (MB) dye in wastewater has raised concern about human health and environmental ecology due to potential carcinogenic, and mutagenic effects. Therefore, this work aims to remove MB dye from wastewater using γ -Al 2 O 3 nanoparticles synthesized from aluminum scrap via simple electrolytic method. The successful synthesis of the adsorbent was confirmed by a range of spectroscopy and microscopy techniques, including XRD, SEM, FTIR, and BET. The central composite design (CCD) of the response surface methodology (RSM) method was used to optimize the processing parameters such as solution pH, contact time, initial MB concentration, and adsorbent dose. The ANOVA results clearly shows that the quadratic model ( p < 0.0001) was sufficient to the best predicting of the removal performance of MB dye (R 2 = 0.9862). The optimum condition for the maximum MB dye removal (98.91%) was achieved at solution pH of 8.298, initial MB concentration of 31.657 mg/L, adsorbent dose of 0.387 g/L, and contact time of 46.728 min. Nano-γ-Al 2 O 3 was shown to have a good surface area of 59 mg 2 /g by BET analysis. The adsorption kinetics follows the pseudo-second-order model (R 2 = 0.997). With a maximum adsorption capacity of 137.17 mg/g, the Langmuir isotherm model (R 2 = 984) provides the best fit to the adsorption isotherm data, indicating a monolayer adsorption process. Furthermore, thermodynamic analysis demonstrated that the adsorption of MB dye was an endothermic and spontaneous process. The reusability study showed that γ -Al 2 O 3 nano-adsorbent retained 85.08% of its original removal efficiency after five cycles. According to the findings of the study, MB dye molecules were taken up by γ -Al 2 O 3 nano-adsorbent via hydrogen bond formation, Van der Waals interaction, and electrostatic attraction. Therefore, γ-Al 2 O 3 nanoparticles can be used as a potentially eco-friendly and low-cost adsorbent for the removal of MB dye from aqueous solutions.

Preparation of thermally recyclable γ-alumina nanoparticles from boehmite for adsorption of anionic dyes: Spectrophotometric study, structural characterization and industrial experience

Preparation of synthetic alumina from aluminium foil waste and investigation of its performance in the removal of RG-19 dye from its aqueous solution

Electrolytic synthesis of γ-Al2O3 nanoparticle from aluminum scrap for enhanced methylene blue adsorption: experimental and RSM modeling

Synthesis, Characterization, and Modification of Alumina Nanoparticles for Cationic Dye Removal

Recovery of binary-component textile wastewater contaminated by reactive dyes through adsorption onto magnetic separable MgO nanoparticles produced from solid waste of ductile cast iron industry, process identifications, characterization and regeneration

Adsorption of Cr(VI) on calcined MgAl-layered double hydroxides and recycling of spent adsorbents for the removal of organic dyes

Zeolite-based adsorbent from alum sludge residue for textile wastewater treatment

Removal of Congo red dyes from aqueous solutions by porous γ-alumina nanoshells

A reusable mesoporous adsorbent for efficient treatment of hazardous triphenylmethane dye wastewater: RSM-CCD optimization and rapid microwave-assisted regeneration

Adsorption Isotherm and Pore Characteristics of Nano Alumina Derived from Sol-Gel Boehmite

α and γ Alumina Spheres for Azo Dye (Allura Red) Removal from Aqueous Media

Efficient removal of refractory dyestuffs from textile wastewater by composite hydrated alumina derived from waste aluminum polishing solution

Direct and Reactive Dyes Recovery in Textile Wastewater Using Calcinated Hydrotalcite

Synthesis of Zeolite Clay/Fe-Al Hydrotalcite Composite as a Reusable Adsorbent for Adsorption/Desorption of Cationic Dyes

Highly Efficient Adsorption of Eriochrome Black T in Wastewater on Mesoporous Alumina Sphere

Synthesis and Characterization of High-Purity Mesoporous Alumina with Excellent Adsorption Capacity for Congo Red

Mesoporous Alumina Microfibers in Situ Transformation from AACH Fibers and the Adsorption Performance

Development of oxidized sodium alginate/silica hybrid as efficient adsorbent for anionic and cationic dyes: mechanism and thermodynamic studies

Effective adsorption and removal of industrial dye from aqueous solution using mesoporous zinc oxide nanoparticles via metal organic frame work: equilibrium, kinetics and thermodynamic studies

Efficient and sustainable treatment of anionic dye wastewaters using porous cationic diatomite

Elimination of a basic dye in liquid waste: an alternative to recycle siliceous by-products of kaolin in the adsorption process of methylene blue