Abstract:Due to their favorable electromechanical properties, such as high sound velocity, low dielectric permittivity and high electromechanical coupling, Aluminum Nitride (AlN) and Aluminum Scandium Nitride (Al1-xScxN) thin films have achieved widespread application in radio frequency (RF) acoustic devices. The resistance to etching at high scandium alloying, however, has inhibited the realization of devices able to exploit the highest electromechanical coupling coefficients. In this work, we investigated the vertical and lateral etch rates of sputtered AlN and Al1-xScxN with Sc concentration x ranging from 0 to 0.42 in aqueous potassium hydroxide (KOH). Etch rates and the sidewall angles were reported at different temperatures and KOH concentrations. We found that the trends of the etch rate were unanimous: while the vertical etch rate decreases with increasing Sc alloying, the lateral etch rate exhibits a V-shaped transition with a minimum etch rate at x = 0.125. By performing an etch on an 800 nm thick Al0.875Sc0.125N film with 10 wt% KOH at 65 °C for 20 min, a vertical sidewall was formed by exploiting the ratio of the 1011¯ planes and 11¯00 planes etch rates. This method does not require preliminary processing and is potentially beneficial for the fabrication of lamb wave resonators (LWRs) or other microelectromechanical systems (MEMS) structures, laser mirrors and Ultraviolet Light-Emitting Diodes (UV-LEDs). It was demonstrated that the sidewall angle tracks the trajectory that follows the 1¯212¯ of the hexagonal crystal structure when different c/a ratios were considered for elevated Sc alloying levels, which may be used as a convenient tool for structure/composition analysis.

Research on AlN thin film microstructure processing technology based on ultra-thin cantilever beam structure

Preparation of AIN Thin Film by DC Sputtering on SiO2/Si and Analysis of Microstructure

Experimental Investigation of Aluminum Nitride Ceramics Based on Compliant Finishing Process

RF Reactive Sputtering AlN Thin Film at Room Temperature for CMOS-compatible MEMS Application

Influence of underlayer roughness on the properties of Sc0.4Al0.6N thin films prepared via sputter deposition

Improving the structural performance of low-temperature sputtered AlN on silicon substrate

Effects of Sputtering Parameters on AlN Film Growth on Flexible Hastelloy Tapes by Two-Step Deposition Technique

Characterisation of Aluminium Nitride Films and Surface Acoustic Wave Devices for Microfluidic Applications

Nanotribological Behavior of Ultra-thin Al 2 O 3 Films Prepared by Atomic Layer Deposition

Preparing aluminum nitride thin film by atomic layer deposition

Study on Microstructure and Mechanical Properties Of（alcrtizrnb）n/al2o3 Nano-multilayer Film

Aluminium Nitride Surface Characterization by Grinding with Laser-Ultrasonic Coupling

Atomic layer deposited high quality AlN thin films for efficient thermal management

Anti-corrosion superhydrophobic surfaces of Al alloy based on micro-protrusion array structure fabricated by laser direct writing

Studies of the Structure and Surface Roughness of AlN Thin Films

Piezoelectric aluminum nitride thin-films: A review of wet and dry etching techniques

Vertical and Lateral Etch Survey of Ferroelectric AlN/Al1-xScxN in Aqueous KOH Solutions

Influence of sputtering parameters on structures and residual stress of AlN films deposited by DC reactive magnetron sputtering at room temperature

Preparation, Characterization, and Application of AlN/ScAlN Composite Thin Films

Metalorganic Chemical Vapor Deposition of AlN on High Degree Roughness Vertical Surfaces for MEMS Fabrication

Improvement of AlN Film Quality by Controlling the Coalescence of Nucleation Islands in Plasma-Assisted Molecular Beam Epitaxy