Abstract:NiO nanomaterials prepared using a solid–liquid NH3·H2O precipitation method (NiO-NSL) were tested in the catalytic combustion of methane. The NiO-NSL presented a characteristic rod-like nanostructure with a length of about a few hundred nanometers except for a part of the nanoparticles. For comparison, the NiO nanomaterials prepared by the traditional liquid-phase NH3·H2O precipitation method (NiO-NLL) were tested in the same reaction conditions. NiO-NSL exhibited significantly higher methane combustion activity than NiO-NLL and achieved the complete combustion of methane at 390 °C, which was outstanding in non-noble metal-based catalyst. X-ray photoelectron spectroscopy (XPS) and hydrogen-temperature-programmed reduction (H2-TPR) results indicate that the surface Ni2+ content of NiO-NSL was higher than that of NiO-NLL, and the presence of more Ni2+ might be responsible for the enhanced activity. DFT calculations prove that the energy barrier for C–H bond activation on Ni2+ was lower than that on Ni3+, which was consistent with the higher methane catalytic combustion activity of NiO-NSL. In addition, when the precipitating agent was replaced with NaOH and (NH4)2CO3, the generalization of the solid–liquid precipitation method in the preparation of the NiO catalysts was also tested. The results show that the solid–liquid precipitation method proposed in this work was still applicable when NaOH was used as a precipitant. However, with the use of (NH4)2CO3 as a precipitant, the methane catalytic activity of the NiO nanoparticles prepared by the solid–liquid precipitation method was reduced to a certain extent compared with the traditional liquid-phase precipitation method. This research can open up a highly efficient and environmentally friendly method for the synthesis of methane combustion catalysts.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsanm.1c00732?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsanm.1c00732</a>.Stability test results of NiO-NSL (Figure S1); wide-angle XRD patterns of the as-precipitated samples using (NH4)2CO3 as the precipitant and a standard xNiCO3·yNi(OH)2 sample (Figure S2); representative TEM images of the precursors and as-calcined catalysts of the other four samples (Figures S3 and S4); specific performance data of samples in previous research (Table S1); XPS analysis of the other samples (Table S2, Figures S5 and S6); H2-TPR profiles of the other samples (Table S3, Figures S7 and S8); detailed DFT calculation results (Table S4); the surface model used in the calculations (Figure S9) (<a class="ext-link" href="/doi/suppl/10.1021/acsanm.1c00732/suppl_file/an1c00732_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Nickel Oxide Nanoparticles on KIT-6: An Efficient Catalyst in Methane Combustion

Ni Based Catalyst Supported on KIT-6 Silica for CO Methanation: Confinement Effect of Three Dimensional Channel on NiO and Ni Particles

Irregularly Shaped NiO Nanostructures for Catalytic Lean Methane Combustion

Nickel Hydroxide Nanosheets Prepared by a Direct Manual Grinding Strategy for High-Efficiency Catalytic Combustion of Methane

Effect of La, Mg and Mo Additives on Dispersion and Thermostability of Ni Species on Kit-6 for Co Methanation

Highly Stable Ni−B/Honeycomb−Structural Al2O3 Catalysts for Dry Reforming of Methane

Highly Active and Stable Lanthanum‐doped Core–Shell‐structured Ni@SiO2 Catalysts for the Partial Oxidation of Methane to Syngas

Partial Oxidation Of Methane To Syngas Over Ni-Based Catalysts

Robust and Coke-free Ni Catalyst Stabilized by 1–2 nm-Thick Multielement Oxide for Methane Dry Reforming

Fine-tunable Ni@porous silica core–shell nanocatalysts: Synthesis, characterization, and catalytic properties in partial oxidation of methane to syngas

Robust Nanosheet-Assembled Al2O3-supported Ni Catalysts for the Dry Reforming of Methane: the Effect of Nickel Content on the Catalytic Performance and Carbon Formation

Porous NiO Nano-Sheet As an Active and Stable Catalyst for CH4 Deep Oxidation

Development of Highly Stable Ni-Al 2 O 3 Catalysts for CO Methanation

One-Pot Synthesis of Hexagonal Mesoporous Silica Confined Ni Based Catalysts with Advanced Co2 Methanation Performance

MoOx-Doped Ordered Mesoporous Ni/Al2O3 Catalyst for CO Methanation

Highly Dispersed Ni Nanoparticles Supported by Porous Al2O3 Rods for Catalytic Dry Reforming of Methane

Partial Thermal Condensation Mediated Synthesis of High-Density Nickel Single Atom Sites on Carbon Nitride for Selective Photooxidation of Methane into Methanol

Mesoporous NiO–CeO2 Catalysts for CO Oxidation: Nickel Content Effect and Mechanism Aspect

Efficient production of hydrogen and carbon nanotubes via the cracking of a waste cooking oil model compound over ordered mesoporous Ni/KIT-6 catalysts

Durable Ni/Mgo Catalysts For Co2 Reforming Of Methane: Activity And Metal-Support Interaction

Facile preparation of a Ni/MgAl2O4 catalyst with high surface area: enhancement in activity and stability for CO methanation