Abstract:NiO nanomaterials prepared using a solid–liquid NH3·H2O precipitation method (NiO-NSL) were tested in the catalytic combustion of methane. The NiO-NSL presented a characteristic rod-like nanostructure with a length of about a few hundred nanometers except for a part of the nanoparticles. For comparison, the NiO nanomaterials prepared by the traditional liquid-phase NH3·H2O precipitation method (NiO-NLL) were tested in the same reaction conditions. NiO-NSL exhibited significantly higher methane combustion activity than NiO-NLL and achieved the complete combustion of methane at 390 °C, which was outstanding in non-noble metal-based catalyst. X-ray photoelectron spectroscopy (XPS) and hydrogen-temperature-programmed reduction (H2-TPR) results indicate that the surface Ni2+ content of NiO-NSL was higher than that of NiO-NLL, and the presence of more Ni2+ might be responsible for the enhanced activity. DFT calculations prove that the energy barrier for C–H bond activation on Ni2+ was lower than that on Ni3+, which was consistent with the higher methane catalytic combustion activity of NiO-NSL. In addition, when the precipitating agent was replaced with NaOH and (NH4)2CO3, the generalization of the solid–liquid precipitation method in the preparation of the NiO catalysts was also tested. The results show that the solid–liquid precipitation method proposed in this work was still applicable when NaOH was used as a precipitant. However, with the use of (NH4)2CO3 as a precipitant, the methane catalytic activity of the NiO nanoparticles prepared by the solid–liquid precipitation method was reduced to a certain extent compared with the traditional liquid-phase precipitation method. This research can open up a highly efficient and environmentally friendly method for the synthesis of methane combustion catalysts.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acsanm.1c00732?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acsanm.1c00732</a>.Stability test results of NiO-NSL (Figure S1); wide-angle XRD patterns of the as-precipitated samples using (NH4)2CO3 as the precipitant and a standard xNiCO3·yNi(OH)2 sample (Figure S2); representative TEM images of the precursors and as-calcined catalysts of the other four samples (Figures S3 and S4); specific performance data of samples in previous research (Table S1); XPS analysis of the other samples (Table S2, Figures S5 and S6); H2-TPR profiles of the other samples (Table S3, Figures S7 and S8); detailed DFT calculation results (Table S4); the surface model used in the calculations (Figure S9) (<a class="ext-link" href="/doi/suppl/10.1021/acsanm.1c00732/suppl_file/an1c00732_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.

Highly Active and Stable Lanthanum‐doped Core–Shell‐structured Ni@SiO2 Catalysts for the Partial Oxidation of Methane to Syngas

Silica-encapsulated Bimetallic Co–Ni Nanoparticles As Novel Catalysts for Partial Oxidation of Methane to Syngas

Partial Oxidation Of Methane To Syngas Over Ni-Based Catalysts

Fine-tunable Ni@porous silica core–shell nanocatalysts: Synthesis, characterization, and catalytic properties in partial oxidation of methane to syngas

Core-shell Structured Ru-Ni@SiO2: Active for Partial Oxidation of Methane with Tunable H2/CO Ratio

Enhancement of CO2 Methanation over La-Modified Ni/SBA-15 Catalysts Prepared by Different Doping Methods

Lanthanum-mediated enhancement of nickel nanoparticles for efficient CO 2 methanation

Highly active Ni/CeO2/SiO2 catalyst for low-temperature CO2 methanation: Synergistic effect of small Ni particles and optimal amount of CeO2

Highly Dispersed Ni-La Catalysts over Mesoporous Nanosponge MFI Zeolite for Low-Temperature CO2 Methanation: Synergistic Effect Between Mesoporous and Microporous Channels

Combined Carbon Dioxide Reforming and Partial Oxidation of Methane to Syngas over Ni−La2O3/SiO2 Catalysts in a Fluidized-Bed Reactor

Irregularly Shaped NiO Nanostructures for Catalytic Lean Methane Combustion

CO2 methanation over rare earth doped Ni based mesoporous catalysts with intensified low-temperature activity

Incorporating Si into NiO support to facilitate oxygen activation for CH 4 combustion

Combined Carbon Dioxide Reforming and Partial Oxidation of Methane to Syngas over Ni−La<sub>2</sub>O<sub>3</sub>/SiO<sub>2</sub>Catalysts in a Fluidized-Bed Reactor

The structure activity relationship of promoted La doped Ni-CeO 2 catalysts prepared by continuous-flow microreactor for low temperature CO 2 methanation

The Structure Activity Relationship of Promoted La Doped Ni-CeO2 Catalysts Prepared by Continuous-Flow Microreactor for Low Temperature CO2 Methanation

Catalytic Partial Oxidation of Methane to Syngas over Ca-Decorated-Al2o3-Supported Ni and Nib Catalysts

Synthesis Chemistry and Properties of Ni Catalysts Fabricated on SiC@Al2O3 Core-Shell Microstructure for Methane Steam Reforming

Enhanced stability of Ni/SiO2 catalyst for CO2 methanation: Derived from nickel phyllosilicate with strong metal-support interactions

Facilely Fabricating Highly Dispersed Ni-based Catalysts Supported on Mesoporous MFI Nanosponge for CO2 Methanation

Influence of Pd and Rare Earth Metals Oxides (Ce, La) as Modifying Additives in the Co,Ni-Oxide Catalyst Compositions on the Process of Methane Oxidation