Abstract:Icing on the wires of overhead power lines is a big problem to maintain their integrity. The process of icing wires leads to a significant increase in their mass and, accordingly, to large overloads on the wire and electric supports. Exceeding the loads above the permissible ones can cause great damage to power lines. Wires, cables can break, fittings can be damaged and even lead to collapse of electrical poles. At the same time, damage is caused from the undersupply of electricity. This damage may exceed the damage from damage to the elements of power lines. Ice on the wires usually appear in winter, especially when the warming is going to be replaced by a cold snap and the temperature fluctuates around zero. The problem can be exacerbated by strong wind loads. An increase in air humidity also accelerates the formation of an ice "coat" on wires and electrical poles. Under the most unfavorable conditions, the wall thickness of the “fur coat” of ice on the wire can reach more than 70 mm. Such an ice coat can lead to exceeding the maximum permissible loads and damage to the power line, as well as damage from a power outage. The mechanism of ice formation on overhead power lines, as well as negative damage to power lines and high-voltage pylons under the action of ice load, has been studied. An analysis of the known methods of dealing with ice on power lines has been carried out. An innovative device for combating icing formations is proposed. The advantage of the proposed device is the ability to operate in two modes: vibrating and shock-shaking, which expands its functionality. In preventive mode, the device operates continuously due to the interaction with alternating current flowing through the wires of power lines in the normal mode of their operation, without the need for shutdown for maintenance, which gives the electromechanical interactions of devices with the wire of the power line a vibrational character and ensures the continuity of the process of removing water drops from the wires at an early stage before ice formation. Thus, in the preventive mode of operation of the power line, the causes of icing of the wires are eliminated, and not its consequences, which eliminates the need to shut down for maintenance, and reduces the required costs of resources and energy.

Operation of Current Protection for the Zero Sequence of Overhead Electric Power Transmission Lines Taking the Circuit for Ice Melting on its Lightning-Protection Cables into Account

Research on Lightning Protection of 220kv Substation with Long Cable Inlet Wire

De-Icing Strategies in Different Stages for Transmission Lines

Study on the Lightning Protection Performance for a 110 kV Non-Shield-Wired Overhead Line with Anti-Thunder and Anti-Icing Composite Insulators

Impact of zero-sequence mutual inductance in UHV Anhui-to-east power transfer lines on phase-earth distance protection

EFFECT OF DISCHARGE CURRENT MAGNITUDE ON EFFECTIVENESS OF OVERHEAD POWER LINE PROTECTION AGAINST DIRECT LIGHTNING STROKES

Analysis on Single-Phase Short-Circuit Current in Insulated Ground Wire During Ice-Melting of EHVAC Transmission Lines

STUDY OF ICE FORMATION PROCESSES ON OVERHEAD POWER LINES AND DEVELOPMENT OF SYSTEMS TO COMBAT THIS PHENOMENON

Research on lightning intruding waves in 220 kV GIS substation

Simulation Research on Suppression Measures Against Severe Ice-Shedding of Ultra-high Voltage Alternating Current Ultra-Long Span Transmission Lines

Simulation Calculation of Transient Voltages on Insulation and Sheath Along 500kV XLPE Submarine Cable

Study on the Prevention of Conductor Ice-Shedding by Interphase Spacer

Estimation of the minimum shielding failure flashover current for first and subsequent lightning strokes to overhead transmission lines

Simulating Calculations of Transient Voltages and Insulation Coordination on 500 Kv AC XLPE Submarine Cable Line

Experimental Investigation on Insulation Configuration for Antiicing on Transmission Lines in Ice Zone

Effects of Lightning Channel Equivalent Impedance on Lightning Performance of Overhead Transmission Lines

Developing a Line Lightning Protection Device to Protect 110 kV Overhead Lines with Ground Wire from Back Flashovers

Modeling and Analysis of Lightning Protection in an Emergency Situation of a Lightning Strike

Simulation and Analysis of Lightning Overvoltage of 10 kV Cable on the Bridge of High-speed Railroad

Research on load transfer melt-icing technology of transmission lines: Its critical melt-icing thickness and experimental validation

Research on Coordination Between Levels of Voltage-Limiting Low Voltage SPD