Abstract:Due to the hidden joint structure, good joining strength, and simple die structure, double-sided self-pierce riveting (DSSPR) has been seen as a potential alternative to self-pierce riveting or resistance spot welding. The chamfered angle position, a new design parameter of tubular rivets, has been proved to influence the joining strength significantly. However, the corresponding mechanism is still unclear. In this paper, the DSSPR experiments of Al 5052 aluminum alloy sheets using tubular rivets with five chamfered angle positions were carried out. The finite element analysis was adopted to clarify the influence mechanism of the chamfered angle position on the joining strength. Mechanical properties and energy absorption were investigated through single-lap shear tests and cross-tension joint pull-out tests. The deformation behavior of sheets and rivet during the DSSPR process were investigated systematically using finite element simulation. The results showed that chamfered angle position has a significant effect on the section structure and mechanical performance of the joint. The shear strength of l = 0.25 and the pull-out strength of l = 0 were about 125% and 221% higher than that of l = 0.5, respectively. In addition, the counter force F 1 influences the rivet expansion direction, and the forces F 2 and F 3 mainly affect the rivet bending degree. The finite element simulation can effectively predict the material flow, stress, and strain distribution of the rivet and sheets during the DSSPR process. When l = 0 or 0.25, the sheet material flows to the outside of the rivet, and a vortex-like phenomenon is formed at the chamfered position. The influence mechanism of the chamfered angle position on the DSSPR process is discussed and explained. The results can provide a deep understanding of the DSSPR process and help to accelerate its engineering application.

Experiment and numerical simulation on the accuracy of hole pieced in the double-sheet piercing application

Steel-aluminum Plastic Clinching of an Inclined Wall Die

Experimental and Numerical Investigation on the Square Hole Hydro-Piercing Process

Finite Element Analysis Of Piercing Process Of Piercing Extrusion For Titanium Alloy Solid Ingots

Numerical and Experimental Investigations of the Two-Step Clinching Process with a Bumped Die

Investigation of micro/meso sheet soft punch stamping process – simulation and experiments

Finite Element Simulation and Quality Control of Hydropiercing Process

Experiments and FE Simulation of Edge Cracking Considering Prehardening after Blanking Process

Deformation Behavior of Curved Shells in Multi-Point Forming with Asymmetric Punches

Investigation of Shearing Extrusion Forming Process Using Finite Element Method

Numerical Simulation on Hydro-Piercing

Finite element modeling and analysis of the self-piercing riveting forming process with the ball-shaped die

Interaction Effect of Cracks and Anisotropic Influence on Degradation of Edge Stretchability in Hole-Expansion of Advanced High Strength Steel

Simulation and Analysis of Self-Piercing Riveting Process in Aluminum Sheets

Research on the Micro Sheet Stamping Process Using Plasticine as Soft Punch

Numerical investigation of joinability and forming quality improvement on self-piercing riveting process with varying sheet stack combinations

Analysis of Multi-Physics Coupling of Small Holes in GH4169 Alloy by Electrolytic Processing of Tube Electrodes

Design and conceptualization of a cutting tool to investigate the influence of the shear cutting process on edge crack sensitivity

Investigations on the Flanging Characteristics of Advanced High-Strength Sheet Metals with Different Sheared Edge Quality

Double-sided self-pierce riveting: analysis of the mechanisms behind the chamfered angle position

Experimental and Finite Element Investigation of Over-Bending Phenomenon in Double-Sided Incremental Forming (DSIF) of Aluminium Sheets