Abstract:Metal flow and penetration fracture behavior is important for application of piercing extrusion process of solid ingots for high-performance seamless tube. A piercing extrusion process from a solid ingot (Phi 200 mm) to a titanium alloy tube (Phi 80 mmx10 mm) has been studied. Based on FE software of DEFORM-2D, a thermo-mechanical coupling model being able to describe the metal flow and penetration fracture behavior was developed for the piercing process of piercing extrusion of solid ingots. The piercing processes by two kinds of piercing punches were analyzed. The results indicate that at the initial stage of piercing process, the deformation characteristic is similar to forward extrusion, and then metal reverse flows, and the backward extrusion remains until the end cap is removed; the piercing force increases rapidly under forward extrusion, and backward extrusion occurs when the force rises to the stable value, and the piercing force decreases rapidly at the penetration fracture stage after removing the end cap; under backward extrusion, the piercing force has a little change by a cylindrical piercing punch, but the force will significantly increase again after a short stable stage by a bottle piercing punch, and thus the piercing force by the bottle piercing punch is much greater than that by the cylindrical piercing punch; at the penetration fracture stage, fracture behavior by the cylindrical piercing punch is similar to that in blanking process, but the fracture face by the bottle piercing punch presents an approximate L-shape.

Numerical Simulation on Hydro-Piercing

Experimental and Numerical Investigation on the Square Hole Hydro-Piercing Process

Numerical Simulation and Sensitivity Analysis for Tube Hydropiercing Quality Based on Experiments

Numerical Simulation of Cavity-Filling Procedures for Micro-Pin-fin Array Thixoforming with Semi-Solid A356 Aluminium Alloy

Finite Element Simulation and Quality Control of Hydropiercing Process

A Numerical Study on the High-Velocity Impact Behavior of Pressure Pipes

Progress and Prospects of FE Simulation of Two-roll Cross Piercing Process

Effect of Internal Pressure Distribution on Thickness Uniformity of Hydroforming Y-shaped Tube

Ductile Fracture Simulation of Hydropiercing Process Based on Various Criteria in 3d Modeling

Influence of Punch Shape on Geometrical Profile and Quality of Hole Piercing-Flanging under High Pressure

Finite Element Analysis Of Piercing Process Of Piercing Extrusion For Titanium Alloy Solid Ingots

Influence of Tube Properties on Quality of Hydropiercing

Structural strength analysis of hydraulic supporting system for inside piercing device about double-action extrusion press

Simulation Study on Hydraulic Supporting System of inside Piercing Device for Double-action Extruder Based on SimulationX Software

Deformation Patterns in Hydroforming of Thin-Walled Y-Shaped Tube

Numerical Simulation for Continuous Extrusion Process of the Flat Multi-Hole Aluminum Tubes

Theoretical Analysis and Numerical Simulation on the Hydraulic Expansion of Double-Layered Tubes

Numerical simulation of shaped charge jet perforating steel target by SPH-FEM coupling method

A Study on Numerical Simulation of Hydroforming of Aluminum Alloy Tube

The Analyzing of Internal Pressure Effect of Hydroforming Three-Diameter Shaft by FEM

Multistep Method in Numerical Simulation of Tube Hydroforming