Abstract:The PSf casting solution required degassing, sealing, and humidity and temperature control.PA layer formation on the top surface of the PSf substrate resulted in the highest FO performance.GO modification of the PA layer considerably enhanced water flux and reduced reverse solute fluxThe FO membranes exhibited high rejection efficiency for dyes used in the textile industry.The application of FO for water recovery is economic and environmentally friendly.In this study, the preparation procedures for the polysulfone (PSf) substrate and polyamide (PA) selective layers were systematically investigated to determine their effects on the separation performance of thin-film composite (TFC) forward osmosis (FO) membranes in terms of the permeate flux (Jw) and reverse solute flux (Js). Furthermore, the PA active layer was modified by adding different proportions of an emerging material, graphene oxide (GO), to increase Jw and decrease Js. The experimental results indicated that special attention should be paid to the preparation of the PSf casting solution, which required thorough degassing, sealing, and humidity and temperature control. The optimum casting height was discovered to be 175 μm. For PA layer formation, the same amount of polymer solutions (resulting thickness of 78.5 μm) on the top surface of the PSf substrate (on the side facing the water during phase inversion) resulted in the highest FO performance. GO modification of the PA layer at the dosage of 0.0175 wt% considerably enhanced Jw to 14 L m−2 h−1 and reduced Js to 0.23 mol m−2 h−1. However, higher GO dosage (0.02 wt%) led to lower membrane performance due to aggregation of GO nanoparticles, as confirmed using scanning electron microscopy. Next, the prepared membranes were applied to dye rejection and sludge concentration for water recovery. The virgin and modified FO membranes both exhibited high rejection efficiency (≥ 96.0%) for dyes commonly used in the textile industry. The 0.0175%-GO-modified FO membrane exhibited a higher concentration factor (1.67) and greater water recovery (40.0%) than the virgin membrane (1.45 and 31.2%, respectively). Therefore, the application of FO for water recovery is economic and environmentally friendly in terms of saving the transportation cost of sludge disposal while recovering water for reuse in wastewater treatment plants.

Development of high-performance electrospun nanofiber based forward osmosis membrane by introducing graphene oxide‐calcium carbonate particle composite intermediate layer

Electrospun nanofiber based forward osmosis membrane using graphene oxide as substrate modifier for enhanced water flux and rejection performance

Graphene Oxide Based Membrane Intercalated by Nanoparticles for High Performance Nanofiltration Application

Preparation and characterization of high-performance electrospun forward osmosis membrane by introducing a carbon nanotube interlayer

Graphene Oxide-Based Membranes Intercalated with an Aromatic Crosslinker for Low-Pressure Nanofiltration

Electrospun nanofiber supports with bio-inspired modification enabled high-performance forward osmosis composite membranes

“Mix-Then-On-Demand-Complex”: In Situ Cascade Anionization and Complexation of Graphene Oxide for High-Performance Nanofiltration Membranes

Construction of facilitated mass transfer composite membrane with triple-layer water nanochannel architecture for forward osmosis process using cGO-coated polysulfone separation membrane as the substrate

High performance forward osmosis membrane with ultrathin hydrophobic nanofibrous interlayer

Polydopamine nanoparticles modified nanofiber supported thin film composite membrane with enhanced adhesion strength for forward osmosis

Design of nanofibre interlayer supported forward osmosis composite membranes and its evaluation in fouling study with cleaning

Triple-layered thin film nanocomposite membrane toward enhanced forward osmosis performance

Chemically Cross-Linked Graphene Oxide as a Selective Layer on Electrospun Polyvinyl Alcohol Nanofiber Membrane for Nanofiltration Application

Construction of Anti-Swelling Circuit Board-Like Activated Graphene Oxide Lamellar Nanofilms with Functionalized Heterostructured 2D Nanosheets

Fabrication and modification of forward osmosis membranes by using graphene oxide for dye rejection and sludge concentration

Towards enhanced performance of fertilizer-drawn forward osmosis process coupled with sludge thickening using a thin-film nanocomposite membrane interlayered with Mxene scaffolded alginate hydrogel

Fabrication of novel thin-film composite membrane based on ultrathin metal-organic framework interlayer for enhancing forward osmosis performance

Synergetic effects of COFs interlayer regulation and surface modification on thin-film nanocomposite reverse osmosis membrane with high performance

Graphene Oxide Modified Graphitic Carbon Nitride As A Modifier for Thin Film Composite Forward Osmosis Membrane

2D COFs interlayer manipulated interfacial polymerization for fabricating high performance reverse osmosis membrane

Polyamide Membrane Tailored by Codeposition of a UiO-66 Metal–Organic Framework Nanostructure-Based Interlayer for Forward Osmosis