Abstract:The PSf casting solution required degassing, sealing, and humidity and temperature control.PA layer formation on the top surface of the PSf substrate resulted in the highest FO performance.GO modification of the PA layer considerably enhanced water flux and reduced reverse solute fluxThe FO membranes exhibited high rejection efficiency for dyes used in the textile industry.The application of FO for water recovery is economic and environmentally friendly.In this study, the preparation procedures for the polysulfone (PSf) substrate and polyamide (PA) selective layers were systematically investigated to determine their effects on the separation performance of thin-film composite (TFC) forward osmosis (FO) membranes in terms of the permeate flux (Jw) and reverse solute flux (Js). Furthermore, the PA active layer was modified by adding different proportions of an emerging material, graphene oxide (GO), to increase Jw and decrease Js. The experimental results indicated that special attention should be paid to the preparation of the PSf casting solution, which required thorough degassing, sealing, and humidity and temperature control. The optimum casting height was discovered to be 175 μm. For PA layer formation, the same amount of polymer solutions (resulting thickness of 78.5 μm) on the top surface of the PSf substrate (on the side facing the water during phase inversion) resulted in the highest FO performance. GO modification of the PA layer at the dosage of 0.0175 wt% considerably enhanced Jw to 14 L m−2 h−1 and reduced Js to 0.23 mol m−2 h−1. However, higher GO dosage (0.02 wt%) led to lower membrane performance due to aggregation of GO nanoparticles, as confirmed using scanning electron microscopy. Next, the prepared membranes were applied to dye rejection and sludge concentration for water recovery. The virgin and modified FO membranes both exhibited high rejection efficiency (≥ 96.0%) for dyes commonly used in the textile industry. The 0.0175%-GO-modified FO membrane exhibited a higher concentration factor (1.67) and greater water recovery (40.0%) than the virgin membrane (1.45 and 31.2%, respectively). Therefore, the application of FO for water recovery is economic and environmentally friendly in terms of saving the transportation cost of sludge disposal while recovering water for reuse in wastewater treatment plants.

Graphene Oxide Modified Graphitic Carbon Nitride As A Modifier for Thin Film Composite Forward Osmosis Membrane

Impact of Graphitic Carbon Nitride/polydopamine on Permeance and Antifouling Performance of Reverse Osmosis Membranes

Graphene Oxide Based Membrane Intercalated by Nanoparticles for High Performance Nanofiltration Application

Electrospun nanofiber based forward osmosis membrane using graphene oxide as substrate modifier for enhanced water flux and rejection performance

Preparation and performance of novel rGO/uCN composite nanofiltration membrane

Role of Graphene Oxide in Support Layer Modification of Thin Film Composite (TFC) Membrane for Forward Osmosis Application

Porous graphene oxide surface-coated thin-film composite membrane for simultaneously increasing permeation performance and organic-fouling migration capacities

Graphene Oxide-Based Membranes Intercalated with an Aromatic Crosslinker for Low-Pressure Nanofiltration

Preparation of Polyethersulfone/carbon Nanotube Substrate for High-Performance Forward Osmosis Membrane

Effect of titanium oxide/reduced graphene (TiO2/rGO) addition onto water flux and reverse salt diffusion thin-film nanocomposite forward osmosis membranes

Construction of facilitated mass transfer composite membrane with triple-layer water nanochannel architecture for forward osmosis process using cGO-coated polysulfone separation membrane as the substrate

Reduced Graphene Oxide-Nh 2 Modified Low Pressure Nanofiltration Composite Hollow Fiber Membranes with Improved Water Flux and Antifouling Capabilities

Effect of poly(2-(dimethylamino)ethyl methacrylate) brush-grafted graphene oxide on polyamide layer formation and nanofiltration performance

Development of high-performance electrospun nanofiber based forward osmosis membrane by introducing graphene oxide‐calcium carbonate particle composite intermediate layer

Fabrication of organic solvent nanofiltration membranes with graphene oxide - Enhanced covalent organic framework via interfacial polymerization

Fabrication and modification of forward osmosis membranes by using graphene oxide for dye rejection and sludge concentration

Fabrication of high performance TFN membrane incorporated with graphene oxide via support-free interfacial polymerization

“Mix-Then-On-Demand-Complex”: In Situ Cascade Anionization and Complexation of Graphene Oxide for High-Performance Nanofiltration Membranes

Polydopamine nanoparticles modified nanofiber supported thin film composite membrane with enhanced adhesion strength for forward osmosis

A Novel Thin-Film Nanocomposite Nanofiltration Membrane by Incorporating 3D Hyperbranched Polymer Functionalized 2D Graphene Oxide

Fabrication and characterization of carbon nanotubes-based porous composite forward osmosis membrane: Flux performance, separation mechanism, and potential application