Abstract:This paper reviews the history, the present status and possible future developments of photovoltaic (PV) materials for terrestrial applications. After a brief history and introduction of the photovoltaic effect theoretical requirements for the optimal performance of materials for pn-junction solar cells are discussed. Most important are efficiency, long-term stability and, not to be neglected, lowest possible cost. Today the market is dominated by crystalline silicon in its multicrystalline and monocrystalline form. The physical and technical limitations of this material are discussed. Although crystalline silicon is not the optimal material from a solid state physics point of view it dominates the market and will continue to do this for the next 5–10 years. Because of its importance a considerable part of this review deals with materials aspects of crystalline silicon. For reasons of cost only multicrystalline silicon and monocrystalline Czochralski (Cz) crystals are used in practical cells. Light induced instability in this Cz-material has recently been investigated and ways to eliminate this effect have been devised. For future large scale production of crystalline silicon solar cells development of a special solar grade silicon appears necessary. Ribbon growth is a possibility to avoid the costly sawing process. A very vivid R&D area is thin-film crystalline silicon (about 5–30μm active layer thickness) which would avoid the crystal growing and sawing processes. The problems arising for this material are: assuring adequate light absorption, assuring good crystal quality and purity of the films, and finding a substrate that fulfills all requirements. Three approaches have emerged: high-temperature, low-temperature and transfer technique. Genuine thin-film materials are characterized by a direct band structure which gives them very high light absorption. Therefore, these materials have a thickness of only one micron or less. The oldest such material is amorphous silicon which is the second most important material today. It is mainly used in consumer products but is on the verge to also penetrate the power market. Other strong contenders are chalcogenides like copper indium diselenide (CIS) and cadmium telluride. The interest has expanded from CuInSe2, to CuGaSe2, CuInS2 and their multinary alloys Cu(In,Ga)(S,Se)2. The two deposition techniques are either separate deposition of the components followed by annealing on one hand or coevaporation. Laboratory efficiencies for small area devices are approaching 19% and large area modules have reached 12%. Pilot production of CIS-modules has started in the US and Germany. Cadmium telluride solar cells also offer great promise. They have only slightly lower efficiency and are also at the start of production. In the future other materials and concepts can be expected to come into play. Some of these are: dye sensitized cells, organic solar cells and various concentrating systems including III/V-tandem cells. Theoretical materials that have not yet been realized are Auger generation material and intermediate metallic band material.

Shift current photovoltaic efficiency of 2D materials

Enhancing Shift Current via Virtual Multiband Transitions

Giant exciton-enhanced shift currents and direct current conduction with subbandgap photo excitations produced by many-electron interactions

Enhancing shift current response via virtual multiband transitions

The shift current photovoltaic effect response in Wurtzite and Zincblende semiconductors via first-principles calculation

Giant Shift Photovoltaic Current in Group V‐V Binary Nanosheets

Recent advances in two-dimensional photovoltaic devices

Shift current response in elemental two-dimensional ferroelectrics

First Principles Calculations of Charge Shift Photocurrent in Vdws Slide Double Layered 2d H-Bn and Β-Ges Homostructures

Engineering graphene and TMDs based van der Waals heterostructures for photovoltaic and photoelectrochemical solar energy conversion

A Strategy for Boosting Photovoltaic Performance Based on a Two-Dimensional ZrSSe/HfSSe Van Der Waals Heterostructure.

Band-Edge Mixture Engineered Giant and Switchable Shift Current Generation

Photovoltaic materials, history, status and outlook

Correlation between electronic polarization and shift current in cubic and hexagonal semiconductors

Structural and Electronic Properties of Hybrid Perovskites for High-Efficiency Thin-Film Photovoltaics from First-Principles

Colossal In-Plane and Out-of-Plane Shift Photocurrents in Single-Layer Two-Dimensional α-Antimonide Phosphorus

Correlation between electronic polarization and shift current in cubic and hexagonal semiconductors LiZn$X$ ($X$ = P, As, Sb)

Approaching The External Quantum Efficiency Limit in two‐Dimensional Photovoltaic Devices

Gate‐Tunable Photovoltaic Efficiency in Graphene‐Sandwiched PdSe2 Photodetectors with Restrained Carrier Recombination

Photovoltaic materials: Present efficiencies and future challenges

Holistic energy landscape management in 2D/3D heterojunction via molecular engineering for efficient perovskite solar cells