Abstract:At present, graphene in two-dimensional carbon nanomaterials is a material with excellent properties. Its preparation technology and application prospects are very wide. The most common one is the chemical redox method, which can make graphite into graphite oxide dispersed in water. Graphene oxide obtained by the Hummers method has a wrinkled structure. In order to broaden the application field of graphene and give full play to its excellent properties, the current research on graphene mainly focuses on the preparation and application of functional composite materials as a matrix material or reinforcement material. Due to its special two-dimensional structure, it has a large specific surface area, good biocompatibility, and stable physical and chemical properties, making it an excellent nanoparticle carrier. The graphene-supported silver nanoparticles can effectively prevent the aggregation and stacking between particles, improve the electrochemical performance of the composite material, and expand its application range. In this article, the assisted preparation of graphene nanosilver composites by 3D printing technology (three-dimensional printing) was studied. 3D printing technology is a rapid prototyping technology that emerged in the 1980s. 3D printing technology is based on discrete stacking and realizes rapid processing of models by directly outputting data from the printing device. In this article, a new type of graphene oxide (GO) was prepared by the modified Hummers method. In the case of NaOH aqueous solution as a catalyst, silver nitrate and GO were used as precursors, and XRD, infrared spectrum, Raman spectrum, and other methods were used. The crystal structure and morphology of Ag/rGO under different conditions were studied, thus revealing the growth of silver particles and the changes of oxidized functional groups under different conditions. It was found that the intensity of the two peaks in the GNs-Ag-2 Raman spectral curve was seven times that of the GNs peak.

Graphene Oxide Based Transparent Resins For Accurate 3D Printing of Conductive Materials

Preparation and Stability of PEGDA/GO Conductive Materials by DLP 3D Printing

DLP 3D Printing of Electrically Conductive Hybrid Hydrogels Via Polymerization-Induced Phase Separation and Subsequent in Situ Assembly of Polypyrrole

Preparation of Graphene Nanosilver Composites for 3D Printing Technology

Direct 3 D Printing of Ultralight Graphene Oxide Aerogel

Fabrication of Conducting Polyacrylate Resin Solution with Polyaniline Nanofiber and Graphene for Conductive 3D Printing Application

Mechanical and Electrical Properties of 3D‐Printed Highly Conductive Reduced Graphene Oxide/Polylactic Acid Composite

Fast and Efficient Fabrication of Functional Electronic Devices through Grayscale Digital Light Processing 3D Printing

Single droplet 3D printing of electrically conductive resin using high aspect ratio silver nanowires

Laser Writing of Eutectic Gallium–Indium Alloy Graphene‐Oxide Electrodes and Semitransparent Conductors

Photo curable resin for 3D printed conductive structures

Rapid High-Resolution Visible Light 3D Printing

Role of GO and Photoinitiator Concentration on Curing Behavior of PEG-Based Polymer for DLP 3D Printing

A novel UV-curable molecular-modified graphene oxide for high-resolution printed electronics

Printability study of self-supporting graphene oxide-laponite nanocomposites for 3D printing applications

Reconfigurable Polymer Networks for Digital Light Processing 3D Printing

Highly conductive, mechanically strong graphene monolith assembled by three-dimensional printing of large graphene oxide.

Digital Light Processing 3D Printing of Lightweight Fe 3 O 4 /rGO/resin Composites with Enhanced Microwave Absorption

3D printing of conducting polymers

High speed 3D material-jetting additive manufacturing of viscous graphene-based ink with high electrical conductivity

Development of Novel 3d Printable Graphene-based Composite Towards Fabrication of Thin Film Electrode Material