Abstract:Mixed oxides of uranium and plutonium U 1-y Pu y O 2-x are currently studied as reference fuel for Sodium-cooled Fast Reactors (SFRs). To predict the margin to fuel melting, an accurate description of both solidus and liquidus temperatures of these materials is crucial. In this work, after a critical review of the literature data, the parameters of the liquid phase of the CALPHAD models of the Pu–O and U–Pu–O systems are reassessed based on the model of Guéneau et al.. A good agreement between the calculated and selected experimental data is obtained. Using this model, the melting behaviour of U 1-y Pu y O 2±x oxides is then studied as a function of plutonium content and oxygen stoichiometry. The congruent melting for the mixed oxides is found to be shifted towards low O/M ratios compared to the end-members (UO 1.97 and PuO 1.95 ). The temperature of this congruent melting is nearly constant (3130–3140 K) along a ternary phase boundary from UO 1.98 to U 0.55 Pu 0.45 O 1.82 and then decreases with Pu content to a maximum of approximately 3040 K for PuO 1.95. This observation is explained by the stabilisation of the hypo-stoichiometric mixed oxides due to the increase of the configurational entropy at high temperatures by the formation of oxygen vacancies and related cation mixing. The influence of the atmosphere used in the laser heating melting experiments on the oxygen stoichiometry of the sample and its solidus and liquidus temperatures is investigated. The determination of this O/M ratio after laser melting tests using XANES is also reported. The simultaneous presence of U 6+ , U 5+ , U 4+ , Pu 3+ and Pu 4+ is observed, highlighting the occurrence of charge compensation mechanisms. The samples are highly oxidised in air whereas close to stoichiometry (O/M = 2.00) in argon. These results are in agreement with the computed solidification paths. This work illustrates the complex melting behaviour of the U 1-y Pu y O 2±x fuels and highlights the need for the CALPHAD method to accurately describe and predict the high-temperature transitions of the U–Pu–O system.

Molten Flux Synthesis of Plutonium (IV) Silicates K2PuSi2O7 and Rb2PuSi6O15

Chemical and Spectroscopic Characterization of Plutonium Tetrafluoride

Plutonium oxide melt structure and covalency

Synthesis, Structural, and Electronic Properties of K 4 Pu VI O 2(CO 3) 3(cr): An Environmentally Relevant Plutonium Carbonate Complex

Flux Method Growth and Structural Analysis of Two Tetravalent Uranium Orthophosphate Single Crystals, Cs2UIV(PO4)2 and Isostructural Cs2(UIV0.75CeIV0.25)(PO4)2

Formation of Fully Stoichiometric, Oxidation-State Pure Neptunium and Plutonium Dioxides from Molecular Precursors

Melting behaviour of mixed plutonium and iron oxides: An experimental study

In situ synthesis of PuCl3 and corresponding Raman and density functional theory vibrational modes

Stabilization of plutonium nano-colloids by epitaxial distortion on mineral surfaces

Magnetic properties of ferromagnetic Pu2Pt3Si5

Investigation of the solid/liquid phase transitions in the U–Pu–O system

Insights into the sonochemical synthesis and properties of salt-free intrinsic plutonium colloids

Diffuse Reflectance Spectroscopy and Principal Component Analysis to Retrospectively Determine Production History of Plutonium Dioxide

Solid-state synthesis of monazite-type compounds containing tetravalent elements

PuCl3{CoCp[OP(OEt)2]3}: transuranic elements entering the field of heterometallic molecular chemistry

A study of plutonium fluoride solubility in LiF–BeF2 melt for the substantiation of a molten salt reactor for Np, Am, Cm transmutation

Uranium–plutonium–oxygen phase diagram: investigating the solvus of fluorite's exsolution

Synthesis of Ca1-xCexZrTi2-2xAl2xO7 zirconolite ceramics for plutonium disposition

Carbene Complexes of Plutonium: Structure, Bonding, and Divergent Reactivity to Lanthanide Analogs

Actinide Endohedral and Exohedral Cubic Siloxanes: An(IV)@(HSiO1.5)(8) and An(IV)&(RSiO1.5)(8) (an = U, Np, Pu; R = H, Cl, OH)

Structural Investigation of δ-stabilized Plutonium Alloys Under Pressure