Abstract:Frequency selective surface (FSS) has extensively been investigated over the past decades. The most famous applications of FSS are used for antennas radome and controlling radar cross section (RCS). FSS radome could reflect the signal out of the band so that the RCS could be reduced by shaping. However, with the development of radar detection technology, the scattering out of the band becomes non-negligible. In order to improve the problem, the FSS rasorber was proposed. It is the combination of the absorber and the radome. In this paper, a wideband transmission FSS rasorber is designed, acting as a stealthy radome to reduce the scattering out of band of the antenna system. The rasorber consists of an absorption layer (LayerA) and a transmission layer (LayerT). The LayerA, which use a resistor-loaded in Jerusalem cross element with non-touching centre, provides stable losses out of band and minimizes losses in the band. The LayerT use as the ground plane of an absorber based on the absorption layer within the total reflection band and providing a transmission window in the band. In order to obtain a wideband transmission, two series chokes are inserted in each leg in the LayerA and the LayerT adopts a second-order resonator. Moreover, the elements are packed densely owing to a skewed grid in the LayerA and the miniaturized non-resonant element in the LayerT. Superdense arrays cause a more stable performance of the rasorber, especially the delay of grating lobes onset. The composite structure is thoroughly analyzed by means of the full-wave numerical simulation. The simulation shows that the -1 dB transmission window is 5.7 ~ 6.7 GHz, and the -10dB reflection band is 2.2 ~ 5.1 GHz. The design would be widely used in broadband antenna system.

A planar stealthy antenna radome using absorptive frequency selective surface

Design of Frequency-Selective Surfaces Radome for a Planar Slotted Waveguide Antenna

A Wideband Transmission Frequency Selective Surface Rasorber

Design of an Invisible Radome by Frequency Selective Surfaces Loaded with Lumped Resistors

A Wideband Transmission Frequency Selective Surface Rasorber with Low Insertion Loss

A Low Radar Cross Section and Low Profile Antenna Co-Designed with Absorbent Frequency Selective Radome

Design of a Wideband Absorption Frequency Selective Rasorber Based on Double Lossy Layers

Enhanced High-gain Antenna Design with Phase-Controlled Frequency Selective Rasorber for LowRCS Performance

Status and Development of Frequency Selective Surface Radome

An Absorptive/ Transmissive Frequency Selective Surface Based Low-RCS Microstrip Antenna Array

A Novel Frequency Selective Surface Loaded with Resistance Films Absobers

A Thin and Broadband Tunable Radar Absorber Using Active Frequency Selective Surface

A broadband reconfigurable rasorber radome based on AFSR for RCS reduction

Design of a hybrid A-sandwich radome using a strongly coupled frequency selective surface element

An FSS-Integrated Low-RCS Radome Design

An FSS-backed Reflective Polarization Conversion Meta-Surface for Radar Stealth

A Miniaturized Absorptive Frequency Selective Surface Applied To The Rcs Reduction

Design and Simulation of a Miniature Thick-Screen Frequency Selective Surface Radome

An Offset Surface to Reduce Radar Cross Section for Airborne Antenna Out‐band

A Low-RCS and Wideband Circularly Polarized Array Antenna Co-Designed With a High-Performance AMC-FSS Radome

Reducing Out-of-band Radar Cross-Section of Metasurface-Based Radome Composites Via Beam-Scattering Mechanism